Page: 74 | Model MRC88 |
will turn the zone “OFF”. (Be sure to set the PLAY command for the proper Source Emitter Output. i.e.
9. Repeat for all zones and commands as required.
NOTE: Remember: As in the example above, to make commands accessible no matter which source is selected, you will need to PUNCH the command (Zone Level).
Command Name | Command Description | Parameter 1 | Parameter 2 |
Zone Power Command | Discrete Power ON or OFF | Zone | PwrState (On, Off) |
Zone Toggle Power Command | Power Toggle Command | Zone | N/A |
Zone Volume Command | Set Volume to preset level | Zone | VolLevel (0 – 63) |
Zone Volume Step Up Command | Increase Volume Setting | Zone | N/A |
Zone Volume Step Down Command | Lower Volume Stetting | Zone | N/A |
Zone Balance Level Command | Set Balance to Preset Setting | Zone | BalLevel |
Zone Balance Step Up Command | Step Balance towards Rt. CH | Zone | N/A |
Zone Balance Step Down Command | Step Balance towards Lt. CH | Zone | N/A |
Zone Treble Level Command | Set Treble to Preset Setting | Zone | TrebLevel |
Zone Treble Step Up Command | Increase Treble Setting | Zone | N/A |
Zone Treble Step Down Command | Decrease Treble Setting | Zone | N/A |
Zone Bass Level Command | Set Bass to Preset Setting | Zone | BassLevel |
Zone Bass Step Up Command | Increase Bass Setting | Zone | N/A |
Zone Bass Step Down Command | Decrease Bass Setting | Zone | N/A |
Zone Source Select Command | Select Source for Zone | Zone | Source |
Zone Mute State Command | Discrete Mute ON or OFF | Zone | MuteState (On, Off) |
Zone Mute Toggle Command | Mute Toggle Command | Zone | N/A |
Zone Restore Balance Command | Restore Balance to Center | Zone | N/A |
Zone Restore Treble Command | Restore Treble to Flat | Zone | N/A |
Zone Restore Bass Command | Restore Bass to Flat | Zone | N/A |
Zone Start Z Adjust Command | Enter ‘Zone Adjust’ Mode | Zone | N/A |
Zone Set Max V Command | Set Maximum Zone Volume | Zone | N/A |
Zone Adjust Done Command | Exit ‘Zone Adjust’ Mode | Zone | N/A |
Zone Start Trim Adjust Command | Set Source Input Trim Setting | Zone | N/A |
Turn Off All Zones Command | Power All Zones OFF | Zone | N/A |
Set Max On V Command | Set Maximum ON Volume Setting | N/A | N/A |
Table 2 – Internal Amplifier Commands
ZONE EXPANSION (CONNECTING MULTIPLE MRC88 CONTROLLERS)
Two MRC88 Controllers can be used to expand the number of zones in a MRC88 system to SIXTEEN. The two MRC88 System Controllers interface via their Expansion port located on the rear of each Controller [Figure 3- (30)].
Connecting two units via their Expansion port, provides for seamless 8 Source / Sixteen Zone operation, allowing the same Zone Linking, Priority Lockout, and Monitor Lockout features throughout all SIXTEEN zones. IR Routing is also supported in this mode.
© 2003 Xantech Corporation