Model MRC88 | Page: 81 |
8.Put the Learning remote into LEARN mode.
9.Select the function to be Taught from the
10.Repeat for all commands to be learned
Figure 43: MRC88 Command Palette
MAKING FINE ADJUSTMENTS
Using an RC68+
TRIMMING SOURCE AUDIO INPUT LEVELS
NOTE: An RC68+ set to code group A8 with overlay “A” is required to set trim levels and make zone adjustments.
This procedure allows all sources to sound equally loud when switching from one to another.
1.Using an RC68+ with overlay “A”, select the input that has the lowest apparent volume level (from any zone).
2.Point the RC68+ at the IR sensor on the MRC88 Keypad (IR sensor enabled) and press the TRIM
button (button F8). This activates the TRIM mode.
NOTE: Trim mode allows 10 seconds after each button press for the next command to be executed. If 10 seconds is exceeded, simply press TRIM again. To confirm TRIM mode, press the MUTE ON button. If the sound mutes, the MRC88 Controller is NOT in the TRIM mode.
3.Select any other input that sounds louder.
4.Adjust VOLUME buttons until the apparent loudness is the same as step 1.
5.Select another input that sounds louder.
6.Adjust VOLUME buttons again until the apparent loudness is the same as step 1.
7.Repeat this procedure for each remaining input.
8.Verify settings by selecting each input again, making adjustments as necessary.
9.When the last input is adjusted, press one more input (the same or any other), to save the last setting.
10.Press the
© 2003 Xantech Corporation