Frymaster MH14, BIH14 warranty To properly filter, the oil or shortening

Pump starts, but no transfer takes place or the transfer is very slow.

	A. To properly filter, the oil or shortening
	should be at or near 350°F (177°C).
	At temperatures lower than this, the
	oil/shortening becomes too thick to
A. Cooking oil/shortening is too cold for	pass through the filter medium easily,
	resulting in much slower oil return
filtering.
	and eventual overheating of the filter
	pump motor. Ensure that the
	cooking oil/shortening is at or near
	frying temperature before draining
	into filter pan.
B. Improperly installed or prepared filter
pan components.	B. Remove the oil from the filter pan
Test: Close the drain valve. Move	and replace the filter paper, ensuring
the filter handle to the OFF position,	that the filter screen is in place under
pull the filter pan (and Power	the paper.
Shower, if so equipped) from the	If this does not correct the problem,
unit. Move the filter handle to the ON
position.	the filter tube suction tube is probably
If a strong stream of air is being	blocked. Remove the blockage using
	a thin, flexible wire. If unable to
pumped out of the oil return port (or	remove the blockage, call FASC.
the Power Shower port), the problem
is with the filter pan components.
C. Improperly installed or prepared filter
pan components.	C. Verify that filter connection o-rings
Test: Close the drain valve. Move	are present and in good condition.
the filter handle to the OFF position,	Replace the filter paper, ensuring
and pull the filter pan (and Power
	that the filter screen is properly
Shower, if so equipped) from the
	positioned under the paper.
unit. Move the filter handle to the ON
position.	If using Magnasol filter assembly,
If a strong stream of air is being	verify that o-ring is present and in
	good condition on filter screen fitting.
pumped out of the oil return port (or
the Power Shower port), the problem
is with the filter pan components.

5-5