Frymaster BIH14, MH14 warranty Installation Instructions

Page 8

CHAPTER 2: INSTALLATION INSTRUCTIONS

2.1General

Proper installation is essential for the safe, efficient, trouble-free operation of this appliance. Any unauthorized alteration of this equipment will void the Frymaster warranty.

DANGER

Copper wire suitable for at least 167° F (75° C) MUST be used for power

connections.

DANGER

The electrical power supply for this appliance MUST be the same as indicated on

the rating and serial number plate located on the inside of the fryer door.

DANGER

This appliance MUST be connected to the voltage and phase as specified on the

rating and serial number plate located on the inside of the fryer door.

DANGER

All wiring connections for this appliance MUST be made in accordance with the wiring diagrams furnished with the equipment. Wiring diagrams are located on the inside of the fryer door.

DANGER

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of

this or any other appliance.

In the event of a power failure, the fryer(s) will automatically shut down. If this occurs, turn the power switch OFF. Do not attempt to start the fryer(s) until power is restored.

This appliance must be kept free and clear of combustible material, except that it may be installed on combustible floors.

A clearance of 6 inches (15cm) must be provided at both sides and back adjacent to combustible construction. A minimum of 24 inches (61cm) should be provided at the front of the equipment for servicing and proper operation.

WARNING

Do not block the area around the base or under the fryers.

The duct system, the hood, and the filter bank must be cleaned on a regular basis and kept free of grease. See the appropriate Maintenance Requirement Cards.

2–1

Image 8
Contents OPERATOR’S Manual Frymaster BIH/MH14 Series Electric Fryer Computers FCC Warranty Statement Parts Return General Safety InformationIntroduction Shipping Damage Claim Procedure Computer InformationService Information Installation Instructions Do not block the area around the base or under the fryersPower Requirements After Fryers Are Under The Fry Station HoodFrypot Boil-Out Introduction to the Analog Controller Equipment Setup and Shutdown ProceduresOperating Fryers With Analog Controllers Description Analog Controller Operating Instructions Operating the BUILT-IN Filtration System BIH14 Series only Description FunctionSTEP-BY-STEP Filtration Instructions Incorrect Correct With fryer off, open drain valve Page Page Care and Cleaning of Your Fryer and Filter System Page Water in the Filter PAN Preventive Maintenance and Troubleshooting Preventive MaintenanceFryer Troubleshooting Troubleshooting Built-in Filtration Systems BIH Series Only Always filter with the cooking To properly filter, the oil or shortening