Xantech installation instructions MRC44 Keypad Feature Descriptions

Page: 10Model MRC44

MRC44 KEYPAD FEATURE DESCRIPTIONS

20 24 26 2722

21

	POWER
23
25						28
32	CH		PAUSE		VOL	29
33	CH		SELECT		VOL	30
		REW	PLAY	FF
34			STOP			31
		STATUS			MUTE

35

Figure 4 – The Model MRC44 Keypad – Front Panel Features and Functions

20.MRC44 Keypad.

21.Power. Turns the zone ON and OFF. Can be programmed with IR codes or sequences.

22.IR Sensor. Receives IR from hand-held remotes to control both source components and the MRC44 system. A Programmable Learning Remote such as the Xantech URC2 is recommended for integrating the IR commands of the MRC44 and source components into a single controller. Compatible with most brands of remote controls, though some may not be programmable and will therefore only control the source components.

23.Status Indicator LED. Will indicate zone/system status and will flash as IR is received at the IR Sensor. These indicators, one for each Keypad, provide the following Information:

a)Off=Zone OFF

b)Steady Green=Zone ON

c)Flash Green=Zone MUTE

d)Flash Red=IR Sensor INPUT or Keypad OUTPUT

e)Flash Amber=System BUSY

24.LCD Display. When the zone power is ON, the LCD will indicate the selected source, zone and system status, zone volume level and other system conditions. The display is automatically backlit when any button is pressed.

25.Source 1 Selector. Selects source input 1, reverses source icon on LCD Display when source is selected and sends IR commands programmed to this button (if any) to the source 1 and common emitter outputs. Also used in Dynamic Monitor Lockout and Dynamic Zone Link Modes.

© 2002 Xantech Corporation