Model MRC44Page: 49
PROBLEM | PROBABLE CAUSE AND SOLUTION |
|
|
I have made hardware connections as shown in Figure | Try the following in the order listed: |
13. However, when attempting to learn IR commands, | a) The default serial port selection (1) in Dragon |
the "Waiting for IR from your Remote" display times out | Drop may already be in use by another device in |
with the "No IR Recorded" dialog box. | your computer system (such as a mouse). Refer |
| to SERIAL PORT SELECTION, page 23, and |
Your computer is not recognizing or finding the serial port | perform the procedure listed there. |
connection to the MRC44. | b) The serial port connections may not be made |
| correctly to the mother board in your computer. |
| This is especially true if you are using a COM port |
| card that permits external connection of COM |
| ports 3 and 4. Have a competent computer |
| specialist check these items. |
| c) Check and replace, if necessary, the connecting |
| cables and the |
| d) The serial COM port settings, such as port |
| addressing and IRQ parameters, may not be set |
| correctly in Windows. Also, with Windows 98, port |
| 4 may be selected instead of 2 in the automatic |
| port selection process (page 23), but not be |
| usable because port 4 is not addressed to a rear |
| panel connector. |
| Again, have a competent computer specialist check |
| these for you. |
|
|
© 2002 Xantech Corporation