Xantech MRC44 Zone Adjustments, IR Sensitivity Adjustment, LCD Backlight Adjustment

Model MRC44 Page: 43

5.Select another input that sounds louder.

6.Adjust VOLUME buttons again until the apparent loudness is the same as step 1.

7.Repeat this procedure for each remaining input.

8.Verify settings by selecting each input again, making adjustments as necessary.

9.When the last input is adjusted, press one more input (the same or any other), to save the last setting.

10.Press the ADJ-OFF (Adjustments Off - 90) button to drop out of the TRIM mode. (TRIM mode will drop out automatically if you wait more than 10 seconds).The TRIM settings are now saved for all zones, completing the procedure.

Zone Adjustments

These adjustments allow customized bass, treble, balance and maximum level settings to best compliment the acoustics and preferences for each zone.

1.Go to desired zone.

2.Using an RC68+ select desired INPUT (source).

3.Point the RC68+ at the IR sensor on the MRC44 Keypad (IR sensor enabled) and press the Z-ADJ button (18). (This activates the Zone Adjustments mode).

NOTE: Z-ADJ mode allows 10 seconds after each button press for the next command to be executed. If 10 seconds is exceeded, simply press Z-ADJ again. To confirm Z-ADJ mode, by press the MUTE ON button. If the sound mutes, the MRC44 Controller is not in the Z-ADJ mode.

4.While listening to the program material, set BASS, TREBLE and BALANCE as desired. Repeat this procedure as often as necessary to arrive at a pleasing tonal balance for the zone.

5.Adjust VOLUME buttons for the maximum volume desired for the zone.

6.Press MAX-V button to save maximum volume.

7.Press the ADJ-OFF button to drop out of the Z-ADJ mode. (Z-ADJ mode will drop out automatically after 10 seconds).The Z-ADJ settings are now saved, completing the procedure.

8.Repeat steps 1 through 7 for each zone.

IR Sensitivity Adjustment

Carefully adjust for background light level to prevent false triggering of the IR circuits.

1.In bright light environments, if the keypad LED is flickering red, use the enclosed small blade screwdriver to adjust the sensitivity of the IR sensor.

2.Slowly turn clockwise to reduce sensitivity until interference no longer affects IR sensor performance.

LCD Backlight Adjustment

Adjusts brightness of LCD backlight. This adjustment does not affect the backlight level for the buttons.

1. Slowly turn clockwise to reduce brightness of LCD on Keypad to desired level.

© 2002 Xantech Corporation