Add/Delete IP Connection
(OMWT-RECIP Receiver only)
OWMT-SOFT-OPC will display the “Add/Delete IP Connection” screen. IP addresses already setup will be displayed. The following is a list of the columns:
Node – Node number for the IP address. OWMT-SOFT-OPC uses this number to identify this IP connection. OWMT-SOFT-OPC uses this number to update the OPC item “nodaladdress”.
IP Address – the IP address that is used to address the receiver.
Port – the port number that is used along with the IP address to address the receiver.
Conn – identifies who initiated the connection. Outgoing: OWMT-SOFT- OPC initiated the connection with the receiver. Incoming: the receiver initiated the connection with OWMT-SOFT-OPC.
Password – initial password used to gain access to the receiver. Description – a general description field associated with the IP connection.
The following is list of buttons in the “Add/Delete IP Connection” screen:
Test – OWMT-SOFT-OPC will try to make a connection to this IP address and report back success or failure.
Add New – OWMT-SOFT-OPC displays the “New IP Address” screen. The following is list of the fields to enter to add a new IP connection: IP Address – the IP address that is used to address the receiver
Port – the port number that is used along with the IP address to address the receiver.
Description– a general description field associated with the IP connection.
Password – initial password used to gain access to the receiver. If the receiver does not have a password set or does not require a password then leave this field blank.
Connection – identifies whether OWMT-SOFT-OPC will initiate the connection or whether the receiver will initiate the connection. Outgoing: OWMT-SOFT-OPC initiates the connection. Incoming: OWMT-SOFT-OPC waits for the receiver to initiate the connection.
Edit – OWMT-SOFT-OPC displays the “Edit” screen showing the selected IP connection. The “Edit” screen has the same fields as the “New IP Address” screen.
Delete – delete the selected IP connection.