2.Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel not the door. Adjust left to right in the mounting bracket before using the pins to adjust the panel up and down or at an angle.
■Slide the panel from side to side in the keyhole slot.
■Use an hex key to raise or lower the adjustment pins which allows the door panel to swivel.
A
B
C |
|
A. Door panel | C. Adjustment pins |
B. Mounting bracket |
|
3.Predrill a ¹⁄₈" deep pilot hole the door panel through the open holes in both the bottom and top hinges.
4.Using slotted hex head screws (provided with refrigerator), attach the top and bottom hinges to the door panels. Fully tighten all door panel screws.
AB
C | D |
A. Top hinge | C. Holes for screws |
B. Mounting bracket | D. Adjustment pins |
5.Using slotted hex head screws (provided with refrigerator) for each side, attach the door panels to the
6.Using Phillips head flat screws (provided with refrigerator), install the handle side door trim.
7.Completely tighten the screws attaching the mounting brackets, located at the bottom of the doors, to the overlay panels.
8.Reinstall the top door trim and hinge cover.
9.Snap the adjustment pin cover (provided with refrigerator) into place.
Install Handles
(Panel Kit Models Only)
IMPORTANT: Install the handles after the door panels have been installed. Follow the instructions specific to your door panel design.
Tools Needed: ³⁄₃₂" hex key
Door Panels - Custom Wood, Stainless Steel and Oiled Bronze Designs
1.Locate the holes in the door panels where the handle mounting studs are to be installed.
2.Fasten the handle mounting studs to the door panels.
3.Install the handles to the handle mounting studs and tighten the setscrews.
Door Panels - Floating Glass Design
IMPORTANT: To align the handle correctly on the door, the plastic handle spacer and the setscrews on the door handle must be in the positions designated in the chart.
1.Locate the holes in the door panels where the handle mounting studs are to be installed.
2.Insert the circular post on the back of the handle spacers into the holes in the door panels.
ABCD
BC
A. Plastic handle spacer
B. Straight handle mounting posts
C. Curved handle mounting posts
D. Circular post
3.Depending on the compartment, rotate the plastic spacer so that the curved handle mounting posts are either at the top or bottom. See following chart.
| Freezer | Refrigerator |
| ||
|
|
|
Curved | Bottom | Top |
Mounting Post |
|
|
|
|
|
Setscrews | Right | Left |
|
|
|
4.Slide the screw into the handle mounting stud. Insert the screw assembly into the center hole of the plastic spacer and fasten it to the door panel.
5.Install the handles to the handle mounting studs so that the setscrews are on the designated side and tighten the setscrews.
23