Install Base Grille
There are two pieces to the base grille to allow for a custom fit: the base grille itself and the skirt. The skirt can be added to the base grille in order to extend it all the way to the floor.
1.To see whether the skirt is needed, place the base grille into position. Do not attach the base grille to the refrigerator. Measure the distance between the bottom of the base grille and the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) in order to add the skirt.
NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skip steps 3 and 4 of the instructions, and install the base grille only.
2.Remove the film from the base grille.
3.Snap the skirt onto the base grille.
A
B
A. Base grille
B.Skirt
4.Trim the skirt by scoring the proper “V” groove with a utility knife. Break the skirt at the score line.
A
A. “V” groove
5.Using the two screws, attach the base grille assembly to the refrigerator as shown.
NOTE: Drive in the right side screw first.
A
A. Screws (2)
Complete Installation
1.Turn the water supply line valve to the “Open” position.
2.Turn the refrigerator switch to the ON position. See “Power On/Off Switch” in the Use & Care Guide for instructions. Wait a few minutes. Check the water line connections for leaks.
3.Remove all boxes, parts packages and packing materials from the interior of the refrigerator. See the “Cleaning” section in the Use & Care Guide for instructions. Remove the film and cardboard from the grille and doors or door frame, depending on your model.
4.Install the shelves and bins in the refrigerator and freezer compartments.
5.The controls are preset at the factory to the midpoint setting. Check that the compressor is operating properly and that all the lights are working.
6.Flush the water system before use. See “Water System Preparation.”
To get the most efficient use from your new
24