Jenn-Air W10430955A Installation Instructions, Unpack Range, Adjust Leveling Legs

Page 9

INSTALLATION INSTRUCTIONS

Unpack Range

WARNING

Excessive Weight Hazard

Use two or more people to move and install range. Failure to do so can result in back or other injury.

1.Remove shipping materials, tape and film from the range. Keep cardboard bottom under range.

2.Remove oven racks and parts package from inside oven.

3.To remove cardboard bottom, place range on its back, take 4 cardboard corners from the carton. Stack one cardboard corner on top of another. Repeat with the other 2 corners.

Place them lengthwise on the floor behind the range to support the range when it is laid on its back.

4.Using 2 or more people, firmly grasp the range and gently lay it on its back on the cardboard corners.

5.Pull cardboard bottom firmly to remove.

6.Use an adjustable wrench to loosen the leveling legs.

7.Place cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto cardboard or hardboard.

Adjust Leveling Legs

1.If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs.

This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position.

NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto the cardboard or hardboard.

2.Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A minimum of ³⁄₁₆" (5 mm) is needed to engage the anti-tip bracket.

NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, then tilt forward to adjust the rear legs.

3.When the range is at the correct height, check that there is adequate clearance under the range for the anti-tip bracket. Before sliding range into its final location, check that the anti- tip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation.

Install Anti-Tip Bracket

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation instructions.

Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed and engaged.

Failure to follow these instructions can result in death or serious burns to children and adults.

1.Remove the anti-tip bracket that is taped to the package containing literature.

2.Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor you can use the wall mounting method.

3.Determine and mark centerline of the cutout space. The mounting bracket can be installed on either the left side or right side of the cutout. Position mounting bracket in cutout so that right (or left) edge of the bracket is 14¹⁄₄" (36.2 cm) from centerline, as shown.

A

B

A.Centerline

B.14¹⁄₄" (36.2 cm)

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Table of Contents/Table des matières Your safety and the safety of others are very important Range SafetyInstallation Requirements Tools and PartsLocation Requirements Product Dimensions Cabinet Dimensions Venting Methods Venting RequirementsWall Venting Floor VentingConcrete Slab Installations Exhaust Through Window Well Concrete Slab Installations Exhaust Through WallCalculating Vent System Length Left or Right Side VentingElectrical Requirements U.S.A. Only If connecting to a 4-wire systemExample vent system Electrical ConnectionIf connecting to a 3-wire system Electrical Requirements Canada OnlyCountertop Preparation Adjust Leveling Legs Installation InstructionsInstall Anti-Tip Bracket Unpack RangeRear Wall Venting Install Downdraft SystemDetermine Equivalent Length of Vent System Floor Mounting Wall MountingTop View Top View View from Motor Side of Blower Power Supply Cord Direct Wire Style 1 Power supply cord strain reliefElectrical Connection U.S.A. Only Removable retaining nut Strain relief Style 2 Direct wire strain reliefWire connection Power Supply Cord Wire Connection Direct Wire Wire Awg Torque Bare Wire Torque SpecificationsGauge copper Lbs-in .8 N-m Gauge aluminum Lbs-in .0 N-m Connect Range to Downdraft System Verify Anti-Tip Is Installed and Engaged Wall Venting Top View Side Venting left side venting shownFloor Venting Top View If you need Assistance or Service Complete InstallationFor power supply cord-connected ranges Moving the RangeFor direct-wired ranges Votre sécurité et celle des autres est très importante Sécurité DE LA CuisinièreExigences D’INSTALLATION Exigences d’emplacementOutils et pièces Dimensions du produit Dimensions du placardExigences concernant l’évacuation Installations dans les régions au climat froidPour obtenir des performances optimales Air d’appointMéthodes d’évacuation Installations sur dalle de béton Évacuation par le murÉvacuation par le mur Évacuation par le plancherExemple de circuit d’évacuation Calcul de la longueur effective du circuit d’évacuationComposant Conduit de diamètre de 15,2 cm Coude à Longueur maximum = 60 pi 18,3 mCuisinières encastrées uniquement Préparation du plan de travailInstructions D’INSTALLATION Déballage de la cuisinièreRéglage des pieds de nivellement Installation du circuit d’évacuation par le Bas Installation de la bride antibasculementDéterminer la longueur équivalente du circuit d’évacuation Montage au plancher Montage muralVue de dessus Évacuation par le mur arrièreVue de dessus Vue du ventilateur coté moteur Placer 2 cales en bois et les fixer au sol Évacuation par le plancher Vue de dessus Évacuation par le mur Vue de dessusAchever l’installation Évacuation latérale évacuation par la gauche illustréeSi la cuisinière ne fonctionne pas, contrôler ce qui suit Si vous avez besoin d’assistance ou de service Déplacement de la cuisinièreCuisinières alimentées par cordon d’alimentation Pour les cuisinières avec câblage direct2011 12/11 All rights reserved W10430955A

W10430955A specifications

The Jenn-Air W10430955A is a premium kitchen appliance designed to elevate culinary experiences and integrate seamlessly into modern kitchens. As a vital component of Jenn-Air's commitment to innovation and performance, the W10430955A represents a fusion of advanced technology and stylish design.

One of the standout features of the W10430955A is its precision cooking technology. This appliance is engineered to provide consistent, even cooking results, thanks to its advanced temperature management system. This system allows home cooks to achieve professional-grade results, whether they are baking, roasting, or broiling.

Moreover, the W10430955A incorporates a sleek, intuitive control panel that simplifies operation. With its user-friendly interface, cooks can easily select settings, adjust temperatures, and monitor cooking times with precision. The touch-sensitive controls not only enhance functionality but also contribute to the overall aesthetic of the appliance, offering a modern touch to any kitchen decor.

In terms of design, the W10430955A features a contemporary look with high-quality materials, including stainless steel finishes that are both durable and easy to clean. The appliance is also designed for energy efficiency, which not only reduces utility bills but also makes it an environmentally friendly choice for those striving to minimize their carbon footprint.

Another commendable characteristic of the W10430955A is its flexibility in cooking options. It often includes multiple cooking modes that cater to various culinary techniques, providing versatility for a wide range of dishes. Whether preparing a delicate soufflé or a hearty casserole, this appliance stands out for its adaptability.

Furthermore, maintenance is hassle-free with this model. Many components are designed for easy removal and cleaning, ensuring that users can keep their appliance in optimal condition with minimal effort.

Overall, the Jenn-Air W10430955A is an exceptional combination of performance, style, and convenience. Its innovative technologies and user-friendly features make it an ideal choice for both amateur cooks and seasoned chefs looking to enhance their culinary skills in a modern kitchen setting. Investing in this appliance not only elevates cooking experiences but also adds a touch of elegance to any home.
Top Page Image Contents