Avanti DW184B ¾ Prepare Hot Water Line, Water Line Connection, ¾ Prepare Electrical Connection

Page 30

¾Prepare Hot Water Line

•The line may enter from either side, rear or floor within the shaded area shown in figure.

•The line may pass through the same hole as the electrical cable and drain hose. Or, cut an additional 1½” dia. Hole to accommodate the water line. IF power cord with plug is used, water line must not pass through power cord hole.

Water Line Connection

•Turn off the water supply.

•Install a hand shut-off valve in an accessible location, such as under the sink. (Optional, but strongly recommended and may be required by local codes.)

•Water connection is on the left side of the dishwasher. Install the hot water inlet line, using no less than 3/8” O.D. copper tubing. Route the line as shown in figure and extend forward at least 19” from rear wall.

•Adjust water heater for 120ºF to 150ºF temperature.

•Flush water line to clean out debris.

•The hot water supply line pressure must be 20-120PSI.

¾Prepare Electrical Connection

WARNING

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center.

WARNING

The electrical installation shown below must be performed by a qualified and

licensed electrician, following all of the electrical codes and ordinances

•This dishwasher should be properly grounded for your safety. The power cord of this dishwasher is equipped with a ground lead which can connect to your grounded permanent wiring system.

•Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly grounded.

•Do not under any circumstances cut or remove the third ground lead from the power cord supplied.

•Remove house fuse or open circuit breaker before beginning installation. Never use an extension cord or adapter plug with the unit.

•Never use a two-prong grounding adapter.

•Where a two-prong wall receptacle is encountered, contact a qualified electrician to have it replaced with a 3-prong receptacle in accordance with applicable electrical codes.

•This dishwasher requires a standard 110/120Volts A.C.~/60Hz electrical power, and connected to an individual properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse.

•The cord should be secured behind the dishwasher and not left exposed or dangling to prevent accidental injury.

6

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Dishwasher / Lavaplatos Table of Contents Avanti Customer Service Help US Help YOUParts and Features Important Safety Instructions Water Heater Safety Before Using Your DishwasherPRE-PROGRAMMED Wash Cycle Buttons PRE-PROGRAMMED Wash CyclesAmount of Detergent to Use Overflow ProtectionsDetergent Dispenser Proper Use Of DetergentHow to Use the Upper Rack Adjusting Rinse Aid DispenserWhen To Refill The Rinse Aid Dispenser How To Use The Lower RackAt The End Of The Wash Cycle Canceling Or Modifying a Wash Cycle SettingStarting a Wash Cycle Forgot To Add a Dish?Cleaning The Door Cleaning The Spray ArmsCleaning The Filters Protect against freezingHow To Keep You Dishwasher In Shape Problems with Your DISHWASHER?Problem Possible Cause What to do Dial until a drain period is reached Wiring Diagram What is Covered Limited ONE-YEAR Warranty Precaucion USO Apropiado Cuando esté cargando los artículos a limpiarSartenes ligeramente Sucios Enjuague 72 ºC Deposito DE Aditivos DE Enjuague Page Advertencia Nunca use el lavaplatos sin filtro Antes DE Llamar AL Servicio Tecnico As Your Primary Residence, Do You Protect your productPromote better products Your AgePage Model Numbers / Número de Modelos DW182ESS / DW183W / DW184B Read Carefully and Save These InstructionsTable of Contents ¾ Before Installation ¾ Water Heater Safety¾ Proper Installation and Maintenance ¾ Parts Supplied Materials For New Installations OnlyFor New Installations Only ¾ Materials You Will NeedDetermine Drain Method ¾ Prepare Dishwasher Enclosure¾ Ways Of Drain Connection Cabinet Preparation¾ Prepare Hot Water Line Water Line Connection¾ Prepare Electrical Connection Cabinet Preparation & Wiring Routing ¾ Before You Begin¾ Check Door Balance And Remove Toekick ¾ Slide Dishwasher Partially Into Cabinet ¾ Level Dishwasher¾ Drain Line Installation ¾ Push Dishwasher Into Final Position¾ Connect Power Supply ¾ Pre-Test Check List¾ Dishwasher Wet Test ¾ Replace The Toekick Antes DE LA Instalacion Para Preparar LA Cavidad DE Montaje DEL Equipo Herramientas NecesariasEN Nuevas Instalaciones Solamente Preparacion DE Apertura Para LA Instalacion DEL LavaplatosPrecaucion Localizacion DE LAS Lineas DE Agua Y ElectricidadInformaciones Importantes DE Seguridad Cuidados CON EL Calentador DE Agua
Top Page Image Contents