•Connect to a grounded metal, permanent wiring system, or run an
•Do not attempt to repair or replace any part of your dishwasher unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.
•To minimize the possibility of electric shock, disconnect this appliance form the power supply before attempting any maintenance.
NOTE: Turning the dishwasher off does not disconnect the appliance from the power supply. We recommend having a qualified technician service your appliance.
Cabinet Preparation & Wiring Routing
•The wiring may enter the opening from either side, rear or the floor within the shaded area.
•Cut a 1½” max diameter hole to admit the electrical cable. Cable direct connections may pass through the same hole as the drain hose and hot water line, if convenient. If cabinet wall
is metal, the hole edge must be covered with a bushing.
NOTE: power cords with plug must pass through a separate hole.
Electrical Connection To Dishwasher. Electrical connection is on the right front of dishwasher.
•For cable direct connections the cable must be routed as shown in figure.
Cable must extend a minimum of 24” from the rear wall.
•For power cord connections, install a
¾Before You Begin
Locate and set aside the 2 Phillips head countertop mounting screws wrapped with yellow tape and stuck to the top or side of the dishwasher.
¾Check Door Balance And Remove Toekick
With dishwasher on wood skid, check the door balance by opening and closing the door.
If door drips open when released, increase spring tension. If door closes when released, decrease tension.
NOTE: Increase or decrease tension as shown. Adjust both springs to the same tension setting to correct balance.
Then remove the toekick.
7