Avanti DW183W, DW184B ¾ Connect Power Supply, ¾ Pre-Test Check List, ¾ Dishwasher Wet Test

Page 34

¾Connect Power Supply

•Remove junction box cover.

•Secure house wiring to the back of the junction box with a strain relief.

•Locate the three dishwasher wires, (white, black and green) with stripped ends. Insert dishwasher wires through the small hole in the junction box. Use wire nuts to connect incoming ground to green, white to white and black to black.

•Replace junction box cover. Check to be sure that wires are not pinched under the cover.

WARNING: If house wiring is not 2-wire with ground, a ground must be provided by the installer. When house wiring is aluminum, be sure to use UL listed anti-oxidant compound and aluminum-to-copper connectors.

¾Pre-Test Check List

Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty.

•Check to be sure power is OFF.

•Open door and remove all foam and paper packaging.

•Read Operating Instructions.

•Check door opening and closing. If door does not open and close freely or tends to fall, check spring cable routing.

•Check to be sure that wiring is secured under the dishwasher, not pinched or in contact with door springs or other components.

•Check door alignment with tub. If door hits tub, level dishwasher.

•Pull lower rack out, about half way. Check to be sure it does not roll back or forward on the door. If the rack moves, adjust leveling legs.

•Check door alignment with cabinet. If door hits cabinet, reposition dishwasher.

•Check that door spring does not contact water line, fill hose, wiring or other components.

•Verify water supply and drain lines are not kinked or in contact with other components. Contact with motor or dishwasher frame could cause noise.

•Turn on the sink hot water faucet and verify water temperature. Incoming water temperature must be between 120ºF and 150ºF. 120ºF minimum temperature is required for best wash performance.

•Add 2 quarts of water to the bottom of the dishwasher to lubricate the pump seal.

•Turn on water supply. Check for leaks. Tighten connections if needed.

•Remove protective film (if present) from the control panel and door.

¾Dishwasher Wet Test

• Turn on power supply.

• Turn the dial to the NORMAL wash position.

• Latch door

• Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power is ON.

• Check for leaks under the dishwasher. If leak is found, turn power supply off, then tighten connections. Restore power after leak is corrected.

• Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinetry. Reposition the dishwasher if necessary.

• The dishwasher will drain about 5 minutes after the first fill. Check drain lines. If leaks are found,

10

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Dishwasher / Lavaplatos Table of Contents Avanti Customer Service Help US Help YOUParts and Features Important Safety Instructions Water Heater Safety Before Using Your DishwasherPRE-PROGRAMMED Wash Cycle Buttons PRE-PROGRAMMED Wash CyclesAmount of Detergent to Use Overflow ProtectionsDetergent Dispenser Proper Use Of DetergentHow to Use the Upper Rack Adjusting Rinse Aid DispenserWhen To Refill The Rinse Aid Dispenser How To Use The Lower RackAt The End Of The Wash Cycle Canceling Or Modifying a Wash Cycle SettingStarting a Wash Cycle Forgot To Add a Dish?Cleaning The Door Cleaning The Spray ArmsCleaning The Filters Protect against freezingProblems with Your DISHWASHER? How To Keep You Dishwasher In ShapeProblem Possible Cause What to do Dial until a drain period is reached Wiring Diagram What is Covered Limited ONE-YEAR Warranty Precaucion USO Apropiado Cuando esté cargando los artículos a limpiarSartenes ligeramente Sucios Enjuague 72 ºC Deposito DE Aditivos DE Enjuague Page Advertencia Nunca use el lavaplatos sin filtro Antes DE Llamar AL Servicio Tecnico As Your Primary Residence, Do You Protect your productPromote better products Your AgePage Model Numbers / Número de Modelos DW182ESS / DW183W / DW184B Read Carefully and Save These InstructionsTable of Contents ¾ Water Heater Safety ¾ Before Installation¾ Proper Installation and Maintenance ¾ Parts Supplied Materials For New Installations OnlyFor New Installations Only ¾ Materials You Will NeedDetermine Drain Method ¾ Prepare Dishwasher Enclosure¾ Ways Of Drain Connection Cabinet PreparationWater Line Connection ¾ Prepare Hot Water Line¾ Prepare Electrical Connection ¾ Before You Begin Cabinet Preparation & Wiring Routing¾ Check Door Balance And Remove Toekick ¾ Slide Dishwasher Partially Into Cabinet ¾ Level Dishwasher¾ Drain Line Installation ¾ Push Dishwasher Into Final Position¾ Pre-Test Check List ¾ Connect Power Supply¾ Dishwasher Wet Test ¾ Replace The Toekick Antes DE LA Instalacion Para Preparar LA Cavidad DE Montaje DEL Equipo Herramientas NecesariasEN Nuevas Instalaciones Solamente Preparacion DE Apertura Para LA Instalacion DEL LavaplatosPrecaucion Localizacion DE LAS Lineas DE Agua Y ElectricidadInformaciones Importantes DE Seguridad Cuidados CON EL Calentador DE Agua
Top Page Image Contents