¾Position Water Line And House Wiring Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher.
¾Insert Drain Hose Through Cabinet
Upright the dishwasher and position in front of the opening. Insert drain hose into cabinet wall hole. If a power cord is used, guide the end through a separate hole.
TIP: Position water line and house wiring on the floor to avoid interference with base of dishwasher.
¾Slide Dishwasher Partially Into Cabinet
Do not push against front panel with knees. Damage will occur.
•Slide dishwasher into the opening a few inches at a time.
•As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the dishwasher is a few inches forward of adjacent cabinetry.
•Make sure drain hose is not kinked under the dishwasher and there is no interference with the water line and wiring or other component.
¾Level Dishwasher
IMPORTANT: Dishwasher must be level for proper dish rack operation and wash performance.
•Place level on door and rack track inside the tub as shown to check that the dishwasher is level.
•Level the dishwasher by adjusting the four leveling legs individually.
•If adjustment to the right rear leveling leg is required,
loosen junction box bracket screw (through the access hole) and rotate bracket clockwise.
TIP: Pull lower rack out, about halfway. Check to make sure the rack does not roll forward or back into dishwasher. If the rack rolls either direction, the dishwasher must be leveled again.
•If door hits tub, the dishwasher is not installed correctly. Adjust leveling legs to align door to tub.
8