Bloomfield 2216 Servicing Instructions Diagnostics & Troubleshooting, Temperature has Recovered

SERVICING INSTRUCTIONS — DIAGNOSTICS & TROUBLESHOOTING)

If the E-Max™ LX goes into an error mode as outlined below, it will probably be necessary to reset the brewer in order to test individual components. Note the reset procedure below:

*FOR “LOW WATER” OR “OVERHEAT” ERRORS: PRESS & HOLD CANCEL FOR 3 SECONDS, OR RE-ENERGIZE THE BREWER (i.e. unplug for a few seconds, the plug in again.)

*FROM “VALVE FAULT” ERROR: THE BREWER MUST BE RE-ENERGIZED Using the CANCEL button will not reset the brewer from “Valve Fault”.

IMPORTANT: The following troubleshooting suggestions are for operator reference only.

All servicing and/or repairs must be performed by qualified service personnel.

FLASHING LIGHTS	ERROR		POSSIBLE PROBLEM & CORRECTIVE ACTION
	LOW WATER TEMP		1.	Water has not reached Precise Temperature
				for Brewing™. WAIT UNTIL WATER
	(Not an error)
				TEMPERATURE HAS RECOVERED.
BREW light and	LOW WATER LEVEL:		1. Sleeve on level sensing probe gasket is too
	Inlet valve has been on			long or sensor not pushed down fully. Sensor
POWER light				should protrude beyond sleeve 1/4”.
	and no water sensed:
flashing				REMOVE TANK LID, CUT SLEEVE TO
	a.	During regular
				PROPER LENGTH. MAKE SURE SENSOR
		operation for 60
				IS FULLY PUSHED DOWN.
		sec., or
	b.	during startup for	2.	Level sensor may be pulled out of tank.
		4-1/2 min.	3.	REINSTALL SENSOR.
				Wiring to sensor may be disconnected or
				faulty. REPAIR WIRING
			4.	Level sensor may be encrusted with scale or
				lime build-up. CLEAN SENSOR (use chemical
				de-liming. Scraping or sanding will damage
				the sensor.
			5.	Water supply may be shut off, or is incapable
				of filling the tank in the allotted time.
				RESTORE WATER SUPPLY.
	VALVE FAULT:		1.	Wiring to either inlet or dump valve not properly
	Detection of a problem
	with the wiring to the			connected. CHECK WIRING / CONNECTORS.
			2.	Controller has two switches for each valve, one
	valve or of the valve
BREW light and				or both has been detected as failing on.
	switching system.
CANCEL light flashing				REPLACE CONTROL BOARD.
	OVERHEAT:		1.	Brew temperature may be too close to max.
	Water temperature has
	exceeded 210ºF			temp. Brew temperature should be no higher
				than 205ºF. LOWER BREW TEMPERATURE
BREW light, CANCEL				SETTING.
			2.	Triac may have failed on, and water continues
light and POWER light				to heat even after controller has tried to turn
flashing				heating element off. CHECK TRIAC,
				REPLACE IF REQUIRED.
			3.	Probe may be defective. TEST ACTUAL
				TEMPERATURE TO VERIFY. REPLACE
				PROBE OR REPAIR WIRING AS REQUIRED.

15