Bloomfield 8781A owner manual ELECTRICIAN’S Installation Instructions

Page 7

Owners Manual 8781A Tea Brewer

NSF requires that the brewer be able to be moved for cleaning underneath. Loops of copper tubing will satisfy this requirement. See Figure 2 below.

Fig. 2 Water Supply Installation

In some areas, local codes require a backflow preventer (check valve) to be installed on the inlet water line. If a backflow preventer is used, you must install a water hammer arrester in the incoming line, between the backflow preventer and the brewer inlet, as far away from the brewer as space will allow. This will relieve the excessive back pressures that can cause faucet leaks and solenoid malfunctions.

ELECTRICIAN’S INSTALLATION INSTRUCTIONS

REFER TO ELECTRICAL SPECIFICATIONS - Page 1 Check the nameplate to determine correct electrical service required for the brewer to be installed.

IMPORTANT: Before connecting to electricity, make sure brewer is connected to the water supply.

Model 8781A is equipped with a cord and plug. It requires a 115 - 125 volt 20 amp circuit (50/60 Hz, 2 wire plus ground, with NEMA 5-15R or 5-20R Receptacle).

INSTALLATION (continued)

NOTE: This equipment must be installed to comply with all applicable federal, state and local plumbing codes and ordinances.

WARNING ELECTRIC SHOCK HAZARD:

Brewer must be properly grounded to prevent possible shock hazard. DO NOT assume a plumbing line will provide such a ground. Electrical shock will cause death or serious injury.

IMPORTANT:

Supply power must match nameplate for voltage and phase. Connecting to the wrong voltage will damage the brewer or result in decreased performance. Such damage is not covered by warranty.

IMPORTANT: Do not connect brewer to electrical power until you are ready to fill the tank.

See instructions at left.

GROUND

PIN

NEMA 5-15P

NEMA 5-15R

PLUG

RECEPTACLE

M628 76201

IMPORTANT: The ground prong of the plug is part of a system designed to protect you from electrical shock in the event of internal damage. Never cut off the ground prong nor twist a blade to fit an exist- ing receptacle. Contact a li- censed electrician to install the proper circuit and receptacle.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 628 Warranty Statement Specifications Table of ContentsApplicability Features and Operating Controls Agency Listing Information Precautions and General InformationPLUMBER’S Installation Instructions InstallationLeveling the Unit ELECTRICIAN’S Installation Instructions InstallationOperation Operational Notes START-UPCoffee HOT Water Faucet Automatic Operation TimerAutomatic Operation POUR-OVER OptionPreparation Brewing CoffeeTea Brew Chamber Brewing TEAFrequency Cleaning InstructionsTools Symptom Possible Cause Suggested Remedy Troubleshooting SuggestionsSymptom Suggested Remedy Front Panel Access PanelsServicing Instructions TOP PanelElevation feet above seal level Temperature AdjustmentReplace Heating Element Solenoid Time AdjustmentRemove Tank LID Assembly Replace ThermostatReplace HOT Water Faucet Coil Clean Solenoid ScreenReplace Timer Assembly Replace SolenoidRepair HOT Water Faucet Replace Control Panel Light or SwitchPrecautions Procedure Delime the Water Tank8781A Exploded Views & Parts List 8781A Exploded Views & Parts List Faucet Repair Kits 8781A Service KitsService Kits Tank LID Assembly8781A Wiring Diagram Telephone Fax
Top Page Image Contents