AEG 4270 I Leak Prevention System, Electrical connection, Appliance is automatically pumped out

Page 37

Installation and Connection Instructions

	Leak Prevention System
	For protection from damage due to water leaks, the dishwasher is
	equipped with a leak prevention system, the AQUA CONTROL SYSTEM.
	In the event of a fault, the safety valve immediately interrupts the sup-
	ply of water to the appliance and the drain pump switches on. By this
	means water can neither escape nor overflow. The remaining water in
	the appliance is automatically pumped out.
1	The AQUA CONTROL SYSTEM also works when the appliance is switched
	off – the appliance must however not be disconnected from the mains.
Electrical connection
1	In compliance with electric company technical requirements for mains
	connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

If the appliance is hard-wired to the mains supply, then it must be safely isolated from the mains within the electrical installation with switches intended to ensure all-pole(N,L1)disconnection, shall be directly connected to the supply terminals and shall have a contact separation (fuses, cut outs, current trips or similar) of at least 3mm in each pole.

37

Image 37

Contents Ökofavorit 4270 Dear customer Tips on using the appliancePlease read these user instructions carefully Use of the appliance are marked with a clover leafContents Installation and Connection Instructions Installation, connection and initial use Safety instructionsChild Safety Intended use General safetyEconomical and Ecological Dishwashing DisposalDisposing of the Packaging Material Disposal of old appliancesAppliance Features and Control Panel Indicators have the following meanings Prior to using for the first timeControl panel Salt Adjust the water softenerHardness range of the water in your area Fill with special salt Filling with Special Salt for the Water SoftenerUse special salt Open the door, remove the lower Rack Turning it anticlockwiseThat you glasses are clear Filling with Rinse AidWould damage the appliance Fill with rinse aidAdjusting Rinse Aid Dosing Loading cutlery and dishes Daily UseNot be washed in the dishwasher Long, pointed items of cutlery Loading CutleryLoad large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans Large PlatesFolded over to the left To ease the loading of large itemsAcross one another Folded across one anotherTwo rear plate inserts in the lower Rack can be folded across one anotherLoading Cups, Glasses and Coffee Services Fill with detergent Filling with DetergentSpecial Advice General AdviceUse of 3 in 1/ Combi Detergent Tablets Bio Wash Programmes and Concentrated Detergents Type of Soiling Selecting the Wash Programme Programme TableStart the wash programme Changing/Interrupting/CancellingWash Programme Changing the wash programmeDishwasher is switched on again Cancelling the wash programmeLoad Sensing Sensor Logic DishwasherSwitching Off the Dishwasher Care and CleaningEmptying the Dishwasher Cleaning the Filter What to do, when Error messages are displayedWash results are not satisfactory Problems occur during use of the dishwasherDishes are still dirty Dishes are wet and dullLower rinse aid dosing Technical DataThere are dried water drops on the glasses and dishes Upper basket Lower basket with cutlery basket Sample loading arrangementsInstalling the Dishwasher Installation and Connection InstructionsBuilt-In Dishwasher Dishwashers That Can Be IntegratedFree-Standing Appliances Work surface must be re-mounted Plinth on free-standing appliances is not adjustableFree-standing appliances can be Fitted with a décor panel to matchWater Connection Connecting the DishwasherPermitted water pressure Connect the inlet hosePlease take care when installing the water inlet hose Water inlet hose with safety valveDrain hose Water drainExtension hoses Sink outlet connectionElectrical connection Leak Prevention SystemAppliance is automatically pumped out Connections Service Departments USA Autres agences étrangères assurant le service après-vente Further after-sales service agencies overseasWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroPage Service AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG