Bosch Appliances HBL 46 Setting the Electronic Clock, Timer, Oven Programmer, To set time of day

Page 11

Oven Programmer

The oven programmer can be used to electroni- cally control the cooking in your oven. Figure 4 shows all the call-outs that are available on the display and their locations. The buttons directly adjacent to the display are the programming but- tons. These are used to program the oven, includ- ing setting the clock.

Figure 4.

Setting the Electronic Clock

When you first turn on the power to your oven, or if the power to the oven has been off for a while the display will come on showing all the call-outs, as shown in Figure 4, and then will become blank, with dashes in the display area and the set clock symbol in the upper right of the programmer dis- play, as shown in Figure 5.

Figure 5.

To set time of day

Press in Set Clock button. A “beep” will be heard. Then press either the plus (+) or minus (-) button, to the right of the display, to set the cor- rect time. If the plus (+) or minus (-) button is pressed it will advance or decrease the time in 1 minute increments, if the plus (+) or minus (-) button is held in the minutes will increase or de- crease in 10 minute increments. Once the time is

properly set depress the Set Clock button again to enter the time. A “beep” will sound and the Set Clock symbol, in the upper right, will disappear.

To change the time of day simply repeat the steps described above. To check the time of day when the timer is in use depress the Set Clock button. The time of day will be displayed briefly and then will return to the timer function.

Timer

The timer acts as a kitchen timer, counting down from the set time.

To Set Timer

Press Timer button. A “beep” will be heard and the display will change from showing the time of day to read zero (.00) and say SET TIMER, to the right, as shown in Figure 6.

Then press either the plus (+) or minus (-) but- ton, to the right of the display, to set the timer to the time interval desired.

Figure 6.

Notes: 1. Each time the plus (+) or minus (-) button is depressed the display will in- crease or decrease in 1 minute incre- ments. If the plus (+) or minus (-) but- ton is held in the display will increase or decrease in 10 minute increments.

2.If the plus (+) or minus (-) button is not depressed within 5 seconds of de- pressing the Timer button the Timer button will have to be depressed again to again call up the timer mode.

Once the desired time interval is set release the buttons.

The timing interval will start after approxi- mately 4 seconds.

9

Image 11
Contents 114192 Page Read ALL Instructions Before Using this Appliance Table of Contents Keep Oven Vent Ducts Unobstructed Read All Instruction Before Using the OvenClean Only Parts Listed in Manual Rack Positions About Your OvenCooling Fan About Convection Ovens Baking ElementsBroiling Elements Convection ElementOven Models Using Your OvenDoor Lock Light Temperature Control KnobMode Selector Heat LightCooking Function Settings Thermal Oven Function Information Cooking Function SettingsOven Programmer Setting the Electronic ClockTimer To Set TimerTo Check Timer During Timed Function To Cancel TimerManual Operation of the Oven Using the Oven ControlsImmediate Start /Automatic Shut-Off To Cancel Cook TimeDelayed Start/Automatic Shut-Off Electronic Control of OvenPage To Check Cook Time To Cancel Delay StartTo Check Start Time/before cooking begins To Change Start Time/before Cooking beginsUsing the Self Clean Function Care & CleaningReplacing an Oven Light To remove the door for 30 models HBL4 Oven Door RemovalTo remove the door for 27 models HBN4 Service and RepairProblem Possible Cause Suggestions Problem SolvingBSH Home Appliances McFadden Avenue Huntington Beach, CA If You Need Assistance or ServiceModel Information Statement of Limited Warranty Model WarrantyPage Manuel d’utilisation et d’entretien Table des matières Lisez toutes les instructions avant dutiliser le four Conseils DE Sécurité ImportantsNe nettoyez que les pièces listées dans le manuel Positions des grilles Détails sur votre fourVentilateur de refroidissement Caractéristiques des fours à convection Les éléments de cuissonÉléments du grilloir Élément chauffant de la convectionUtilisation de votre four Modèles de foursLumiére de fermeture de la porte Sélecteur de modeLumière allumée/éteinte Le voyant lumineux de chaleurTableau 3. Réglages des fonctions de cuisson Réglage des fonctions de cuissonFour thermique Information sur les fonctions Réglage de lheure Programmeur de fourLe minuteur Réglage de lhorloge électroniqueVérification du minuteur durant une fonc- tion minutée Annulation du minuteurFonctionnement manuel du four Usage des commandes du fourAllumage retardé/Fermeture automatique Contrôle électronique du fourAllumage immédiat/Fermeture automatique Annulation du temps de cuissonPage Changement de la durée de cuisson Vérification de la durée de cuissonUtilisation de la fonction dauto-nettoyage Nettoyage et entretienRéglez le bouton de la température à Clean Remplacement dune lampe de fourEnlevement de la porte de four Pour enlever la porte pour 27 en modèles HBN4 Service et réparationSolution des problèmes Informations sur le modèle Si vous avez besoin dassistance ou de serviceDéclaration de garantie limitée Page Code 09BH0320 TPS Gallarate