Antunes, AJ MS-150/155 Operation, General All Units Except MS-150/250 Mfg. #9100424, 432, 433

General (All Units Except MS-150/250 - Mfg. #9100424, 432, 433 & 439)

When the Operate button (Figure 5a) is pressed, power is supplied to the water pump (MS-150/155/355) or the solenoid valve (MS-250/255). The pump/solenoid operates and water sprays onto the heated Steam Generator. The water flashes immediately into live steam and shoots down onto the product.

General (MS-150/250 - Mfg. #9100424, 9100432, 433, & 9100439 Only)

When the Single Shot button (Figure 5b) is pressed, power is supplied to the Solenoid/Water Pump. The solenoid/ water pump operates and water sprays onto the heated Steam Generator. The water flashes imme- diately into live steam and shoots down onto the prod- uct.

One of two operational modes can be used:

Single Shot or Timed Cycle

One of two operational modes can be used: Single Shot or Timed Cycle

SINGLE SHOT

The Operate button is pressed to initiate a single steam shot. The control board applies power to the water pump/solenoid and a “shot” of steam occurs.

TIMED CYCLE

The control is used to set the desired cook time (up to 99 minutes, 59 seconds). When the Start/Stop but- ton is pressed, the Control Board applies power to the water pump/solenoid at regular intervals for the dura- tion of the displayed cycle time. The display counts down to zero and, when the cycle is complete, sounds an audible signal, and then reverts back to the original programmed cycle time. The unit is ready for the next cycle when the green ready light is on.

SINGLE SHOT

The Single Shot button is pressed to initiate a single steam shot. The Control Board applies power to the Solenoid/Water pump and a “shot” of steam occurs.

TIMED CYCLE

The control is used to set the desired cook time (up to 99 minutes, 59 seconds). When the Operate but- ton is pressed, the Control Board applies power to the solenoid at regular intervals for the duration of the displayed cycle time. The display counts down to zero and, when the cycle is complete, sounds an audible signal, and then reverts back to the original programmed cycle time. The unit is ready for the next cycle when the green ready light is on.

Ready Light

Message

Display

Start/Stop

Button

Operate

Button

Rocker Switch (Power On/Off)

Figure 5a. Operating Controls (all units EXCEPT MS-150/250 Mfg. #9100424, 9100432, 9100433, & 9100439)

Figure 5b. Operating Controls (MS-150/250Mfg. #9100424, 9100432, 9100433, &9100439 ONLY)