PlacingtheDishwasher/SecuringtheDishwasher
_L
14"
355mm) _/
J
Figure 19
PLACmNG THE DISHWASHER
1Straighten and position the hot water supply line and the electrical supply cable as shown in Figure 19 so
that they wiii align with their channels under the dishwasher base,
2Position the dishwasher close enough to the enclosure
so that you can run the dishwasher drain hose to the under sink drain connection, Make certain that the hot
water supply line and the electrical supply cable are in their channels under the dishwasher base, as shown in Figure 20,
3Slide the dishwsher into the opening making sure that the hot water supply line and the electrical supply cane stay in their proper channels,
4Make sure the dishwasher is level, Adjust the rear leveler by turning the center screw at the front of the dishwasher, as shown in Figure 21a, Turning the screw clockwise raises the rear of the dishwasher, Adjust the front levelers by turning them with a screwdriver, as shown in Figure 21b, Turning the levelers to the right raises the dishwasher, if additional height is needed, shims may be added under the leveler feet,
Hot Water Supply Line
and Electrical Supply
Cable Position in
Channels
J
Figure 20
SECURING THE DISHWASHER
1Drive the mounting screws through the hobs in the
mounting brackets as shown in Figure 22 for Top or Side Mount.
Figure 21
f
Figure 22
10