Base and Toe Pane,/Final Instructions
BASE AND TOE PANEL (Continued)
PJaetic Base Access PaneJ and Toe PaneJ installation (SHY66C, SH×99A, SH E66C, SHE99C, SH×57C, and SHV57C modete only)
1PUacethe PUastb Base Access PaneUunder and up the front bottom paneUof the dishwasher, as shown in Figure 34a,
2insert the PUastb Base Access PaneUscrews into the PUastb Base Access PaneU,as shown in Figure 34b, Tighten the PUastb Base Access PaneUScrews,
3PUace the Cotton UnsuUationStrip under the unit, between the bottom of the Plastic Base Access Panel and the floor, as shown in Figure 34c,
4Attach the Toe Panel to the Plastic Base Access Panel using the Toe Panel Screws included in the Toe Panel Installation Kit, See Figure 34d,
NOTE: You will not use the normal Toe Panel Screws included in the Dishwasher Installation Kit on these models,
In some conditions, Hydrogen gas can form in a hot water system that has not been used for weeks. Hydrogen gas is e×pJoeive. Before filling a dishwasher from a system that has been off for
weeks, run the water from a nearby faucet in a wett ventilated area untit there is no sound or
evidence of gas.
FINAL mNSTRUCTmONS
1Energize the dishwasher power supply circuit,
2Consult the Dishwasher Use and Care Manual, and run the dishwasher through one complete cycle, if the dishwasher does not operate properly, refer to the Self- Help section of the Use and Care Manual, if the
dishwasher still does not operate properly, refer to the Customer Service Section of the Use and Care
Manual,
15