EmectricalConnection/Door Tension Adjustment/Base and Toe Panel
ELECTRICAL CONNECTmON (continued) |
Fire Hazard
To avoid a fire hazard, make sure there are no toose eJectrical connections. Make sure aH
etectricaJ connections are properly made.
o Do not
o Extend the dishwasher's stranded wires 1/8" (3mm) beyond the power supply cable's solid wires, as shown in Figure 30,
5Using the supplied wire nuts, connect the electrical supply wires to the dishwasher's wires, black to black,
white to white, and green or bare, Make certain that the insulated wires show no bare wire from the
bottoms of the wire nuts, Gently tug the wires to make certain they are securely connected,
6Press the wires into the junction box as shown in
Figure 31, Make certain that the wire nuts do not loosen,
7Place the cover on the junction box and secure it to the junction box with the supplied screw,
DOOR TENSION ADJUSTMENT (only on SHI
Figure 31and SHV mode_s with custom door pane_s) After the dishwasher and custom door panel are installed,
open and close the door several times to make sure that it does so with ease, If the door falls open too quickly, the spring tension needs to be adjusted,
To Adjust the Spring Tension:
1Obtain the provided Spring Tension Screws from the SHI/SHV Door Panel Installation Kit,
2insert the screws as shown in Figure 32, Turning the screw clockwise increases the spring tension,
Figure 32
Figure 33
J
TOE PANEL mNSTALLATmON
Regutar Toe Panel installation
Use the toe panel screws from the Dishwasher Installa° tion Kit and a %20 screwdriver to install the toe panel as shown in Figure 33,
14