30 _E
(762mm)
21 EE
(533mm)
Figure 4
Dishwasher E_ectrica_ Rating
VeltsAmperes Watts
120 60 15 1,450
(max)
3" A,, 1
( 75mm ° lOOmm1.
3/8"- | 1/2" | _ | I | .< |
( 8mm- | 13mm) |
| ||
| Figure | 5 |
|
|
Electrical Shock Hazard
To avoid electdcaJ shock, do not work on an energized circuit. Doing so could resuJt in serious injury or death. Onty qualified electricians should perform electrical work. Do not attempt any work
on the dishwasher etectric suppty circuit until you are certain the circuit is
Fire Hazard
To avoid a fire hazard, make sure electrical work is properly installed. OnJy qualified electricians shouJd perform eJectrical work.
Electrica! Supply
The customer has the responsibility of ensuring that the dishwasher electrical installation is in compliance with all national and local electrical codes and ordinances. The dishwasher is designed for an electrical supply of 120V, 60 Hz, AC, connected to a
Regardless of where the electrical supply cable enters the enclosure, position the cable 21" (533mm) from the enclosure's left side, as shown in Figure 4. Extend the cable 30" (762mm) from the enclosure's back, as shown in Figure 4.
Remove 3" =4" (75mm =lOOmm) of the cable'souter casing, as shown in Figure 5, then remove 3/8" - 1/2" (9 - 13mm) of insulation from each wire, as shown in Figure 5.