Toe
PaneH
Figure 12
Figure 13
Dishwasher Preparation
DmSHWASHER PREPARATmON (continued)
Removing the Toe Pane1 FleguJar Toe PaneJ
The toe paneHis HooseHyattached with tape, Remove the tape and puHHthe toe paneHaway from the dishwasher, Set the toe paneHaside, HtwHHbe reinstaHHedHater,
PJastic Base Access Panel and Toe PaneJ (SHY660, SHX99A, SHE660, SHE990, SHX570, and SHV570 modeJe only)
The pHasticbase access paneHand toe paneHare in pHace on the dishwasher, but are not attached, Remove the toe paneHfirst, as shown in Figure 12, then remove the pHasticbase access paneH,as shown in Figure 12,
Installing the 90 ° Elbow Fitting
NOTE: The 90° eHbowfitting is not suppHiedwith the dishwasher, and must be purchased separateHy, Hfthe dishwasher's hot water suppHy Hineis to be copper tubing, make certain the eHbowhas a compression fitting, AppHyTeflon tape or other pipe seaHantwhen required, Orient the hot water suppHyconnection Hegof the eHbow toward the channeHopening in the dishwasher base, See Figure 13,
Junction Box Preparation
1Remove junction box cover (see Figure 14) by HiRing the junction box cover up and off,
2Remove the strain reHiefpilate by removing the screw at the back of the junction box, as shown in Figure 15 and sHidingthe strain reHiefpilate out,
3Set the junction box cover, strain reHiefpilate, and screw aside, They wiHHbe
Figure 14 | Figure 15 |
8