PRE-INSTALLATION REMINDERS
The information on the Quick Start Guide is intended for ease of use and application, the following reminders will help to ensure your satisfaction with MicroTek products and service.
1.Read through this manual before bench testing and installation
2.Perform a bench test incorporating all components of the application
3.Install your MiniLink Wireless Ethernet System
4.Toll-free technical assistance is available Monday through Friday (8-5pm PST) at 888-366- 4276
MICROTEK ELECTRONICS RETURN POLICY
MicroTek Electronics products come with a 2-year limited warranty, (see the last page for warranty information) unless otherwise specified. In addition to the 2-year warranty, products may be returned within thirty (30) days of shipment provided the products are in like new condition and in the original packaging. Contact your MicroTek Electronics dealer or distributor to obtain an authorization to return the merchandise for credit.
Return authorizations for repair can be sent directly to Microtek Electronics with a valid RA number. Call MicroTek Electronics to obtain an RA number for repair.
ETHERNET STANDARD WIRING NOTE
The Ethernet standard straight-through cable configurations used must be configured to one of the two Ethernet standards (568-A or 568-B) in order for the WES system to operate correctly. Any deviation from one of the two standard configurations can lead to undesired activity so make sure your cables are configured as shown in one of the drawings below:
•Drawing shown with gold pins facing up and RJ-45 clip in rear (clip not shown)
•If 568-B is configured on end of a CAT5 cable and 568-A is configured on the other end, that configuration would be a standard crossover cable.
-3 -
