Morphy Richards BM48322 manual Questions About General Performance Operation

48322 a4:45xxx rev1 11/01/2010 09:26 Page 14

F.A.Q.

Questions About

General

Performance and

Operation.

Question 1

What should I do when the kneading blade comes out with the bread?

This is normal, remove it with a pair of plastic tongs before slicing the bread. Since the blade disconnects from the pan for cleaning, it is not a malfunction when it comes out in your bread.

Question 2

Why does my bread sometimes have some flour on the side crust?

In some cases, the flour mix may remain on the corners of the baking pan. When this happens, simply trim off that portion of the outer crust with a sharp knife.

Question 3

Why isn't the dough mixing? I can hear the motor running. The Kneading Blade or baking pan may not be inserted properly. Make sure the pan is facing the right way and that it has ‘clicked’ and seated into the bottom of the breadmaker.

Question 4

How long does it take to make bread?

Timings for each setting are outlined on page 12.

Question 5

Why can't I use the timer when baking with fresh milk?

The milk will spoil if left sitting in the machine too long. Fresh ingredients such as eggs and milk should never be used with the delayed timer feature.

Question 6

Why do I have to add the ingredients in a certain order? This allows the breadmaker to mix the ingredients in the most efficient manner possible. It also serves to keep the yeast from combining with the liquid before the dough has started to mix, which is essential on the time delay.

Question 7

When setting the timer for morning, why does the machine make sounds late at night?

The machine must start operation when the time delay reaches the start time of the programme so that the bread will be ready. These sounds are made by the motor when kneading the dough. It is a normal operation, not a malfunction.

Question 8

The kneading blade is stuck in the bread pan. After baking how do I get it out?

The kneading blade may ‘stick’ in place after baking. Running warm or hot water over the blade should loosen it enough to be removed. If still stuck, soak in hot water for about 30 minutes.

Question 9

Can I wash the baking pan in the dishwasher?

No. The baking pan and kneading blade must be washed by hand.

Question 10

What will happen if I leave the finished bread in the baking pan? Whilst still in the breadmaker for the first hour after baking is complete the bread ’keeps warm’ to prevent it becoming ‘soggy’. Leaving the bread in the breadmaker after the keep warm period may result in a ‘soggy’ loaf of bread as excess steam (moisture) would not be able to escape. Remove and allow to cool on a wire rack after baking to prevent this.

Question 11

Why did the dough only partially mix? Why didn't it mix completely?

The dough may be too heavy or dry. Also, the kneading blade or baking pan may not be inserted properly. Ingredients may have been added in the wrong order.

Question 12

Why didn't the bread rise? The yeast could be bad, past it’s sell by date or possibly no yeast was added at all. Also, if the mixing was not complete, rising problems could develop.

Question 13

Why can't the delayed finish be set for more than 12 hours? What is the minimum time a cycle may be delayed?

The maximum length of delay is 12 hours including the total cycle time. For example, Setting 1 (basic 2lb) has a cycle time of 3:00. This start is delayed by a maximum of 9:00. The minimum length of delay for each setting is 10 minutes. The delay clock increases and decreases in increments of 10 minutes.

Question 14

How do I know when to add raisins, nuts, etc. to the bread? There is a beeper tone to signal that you may add raisins, nuts, etc. during the second kneading cycle. Note: See ‘Baking cycle times’ chart for ‘Add nuts & raisins’ time. On the 48323 model with the fruit and nut dispenser, this is automatic.

In some cases, ingredients can be broken up during the initial kneading cycle. Each recipe indicates the best time to add fruit and nuts to the dough.

Question 15

Why does my bread come out too moist? What can I do? Humidity may affect the dough. Add an extra tablespoon of flour. Also, high altitude may have the same effect. Decrease the amount of yeast by 1/4 teaspoon and decrease the sugar and/or water/milk slightly.

Question 16

Why do I get air bubbles at the top of the bread?

This can be caused by using too much yeast. Decrease the yeast by 1/4 tsp.

Question 17

Why does my bread rise and then collapse or crater?

The bread may be rising too much. To reduce the rate of rising, reduce the amount of yeast and/or increase the amount of salt.

Question 18

Can I use my favourite bread recipes (traditional yeast bread) in my bread machine?

Yes, but you will need to experiment to get the right proportion of ingredients. Become

14 UK Helpline 0844 871 0944 Replacement Parts 0844 873 0710 Ireland Helpline 1800 409 119