Middleby Marshall PS360-U installation manual English, For Your Safety

Page 2

ENGLISH

NOTICE:

This Owner's Operating and Installation Manual should be given to the user. The operator of the oven should be familiar with the functions and operation of the oven.

This manual must be kept in a prominent, easily reachable location near the oven.

Gas ovens are designed for use with EITHER natural gas OR liquid propane gas, as specified on the serial plate. Where permitted by local and national codes, the oven can be converted from natural gas to propane operation, or from propane to natural gas operation. This conversion is described in the Installation section of this Manual. The conversion requires the installation of the appropriate Middleby Marshall Gas Conversion Kit.

It is suggested to obtain a service contract with a Middleby Marshall Authorized Service Agent.

WARNING

POST, IN A PROMINENT LOCATION, THE EMERGENCY TELEPHONE NUMBER OF YOUR LOCAL GAS

SUPPLIER AND INSTRUCTIONS TO BE FOLLOWED IN THE EVENT YOU SMELL GAS.

Instructions to be followed in the event the user smells gas shall be obtained by consulting the local gas supplier. If the smell of gas is detected, immediately call the emergency phone number of your local Gas Company. They will have personnel and provisions available to correct the problem.

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors or liquids in the vicinity of

this or any other appliance.

WARNING:

Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment.

IMPORTANT

An electrical wiring diagram for the oven is located inside the machinery

compartment.

IMPORTANT

It is the customer's responsibility to report any concealed or non-concealed damage

to the freight company. Retain all shipping materials until it is certain that the

equipment has not suffered concealed shipping damage.

NOTICE: CONTACT YOUR MIDDLEBY MARSHALL AUTHORIZED SERVICE AGENT TO PERFORM MAINTENANCE AND REPAIRS. AN AUTHORIZED SERVICE AGENCY DIRECTORY IS SUPPLIED WITH YOUR OVEN.

NOTICE: Using any parts other than genuine Middleby Marshall factory manufactured parts relieves the manufacturer of all warranty and liability.

NOTICE: Middleby Marshall (Manufacturer) reserves the right to change specifications at any time.

NOTICE: The equipment warranty is not valid unless the oven is installed, started and demonstrated under the supervision of a factory certified installer.

Retain This Manual For Future Reference

Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • USA • (847)741-3300 • FAX (847)741-4406

24-Hour Service Hotline: 1-(800)-238-8444

www.middleby.com

2

Image 2
Contents 40kW 50kW 2x40kW 2x50kW Rev. B V1 7/01PS360 26kW 2x26kWFor Your Safety EnglishTable of Contents Oven Uses III. Oven SpecificationsDescription English Gas orifice and pressure specifications per oven cavity InstallationElectrical specifications per oven cavity Additional installation kit components for gas ovens Installation KITInstallation kit components one kit required per cavity 710Recommendations II. Ventilation SystemRequirements Other ventilation concernsIII. Assembly IV. Thermocouple InstallationConveyor Installation Removing the Conveyor Drive SprocketVI. Final Assembly 11 Conveyor and Master Link OrientationAdditional Information Gas Ovens VII. Electrical SupplyVIII. GAS Supply Additional Information Electric OvensGas Line Gas Utility Rough-In RecommendationsGas Meter Preparation for Use with Various Gases Replacing the Gas Orifices if so requiredChecking the Gas Supply Inlet Pressure Adjusting the Orifice Manifold Pressure and Heat InputVolumetric Method Orifice Manifold Pressure MethodOperation Conveyor Switch Turns the conveyor drive motor on and offReset Switch Gas ovens only. Illuminates Location and Description of ControlsII. Normal Operation STEP-BY-STEP III. Quick Reference Digital Temperature Controller IV. Quick Reference Troubleshooting SymptomMaintenance Maintenance DailyII. Maintenance Monthly Removing the ConveyorIII. Maintenance Every 3 Months Split Belt Disassembly and CleaningIV. Maintenance Every 6 Months 10 Key Spare Parts KitDiagrams 400V, 50 Hz, 1 PhGas Oven 230V, 50 Hz, 1 Ph