APW Wyott AT/BT Series, M Series manual Installation AT Series, Electrical information AT-200

Electrical information - AT-200

Each toaster is equipped with a 4 foot (122 cm), 3 wire grounded power supply cord which terminates with a 3 prong plug (6-50P).

MODEL NUMBER	AT-200
Overall Dimensions with Superfeeder	18 3/8"H X 15 3/4"W x 26 1/2”D (46.7 cm x 40 cm x 67.4cm)
Stock Number/Electrical	208V-5600W-27.0 amps
	230V-5145W-22.4 amps-50 Hz
	240V-5600W-23.4 amps
Productivity (Fresh Product)	( 208V/240V )-1200
Bun Halves per hour
Bread/toast sliced per hour	( 208V/240V )-1400
Croissants per hour	( 208V/240V )-1400
English muffins per hour	( 208V/240V )-1000

Net/Shipping Weight

68 Lbs./75 Lbs. (30.9/34.1 kg)

INSTALLATION - AT SERIES

A.UNPACK UNIT

1.Remove unit from shipping carton, unwrap loose parts and remove any packing tape.

2.Refer to the illustration below and account for the following parts:

a)(4) legs - wrapped, internal package

b)Bread Slide - shipped in place

c)Bread Drawer - shipped in place

d)Reflector/Crumb Tray - shipped in place

e)Superfeeder (optional) - wrapped, internal package

f)Instruction manual -wrapped, internal package

B.	ASSEMBLY		Superfeeder
	1.	Lay the toaster on its side and install
		four adjustable legs into threaded
		holes in base. Tighten legs with
		crescent wrench. The unit may be
		leveled by unscrewing the lower	Reflector/Crumb Tray
		insert of each leg. Precise leveling is	Bread Slide
		not required for proper operation of	Bread Drawer
		the toaster. Set the toaster upright.
		CAUTION: DO NOT OPERATE THE
		TOASTER WITHOUT THE LEGS		Studs	Legs
		INSTALLED.

2.Refer to the illustration and check that the Reflector/Crumb Tray is in the proper position.

CAUTION: DO NOT OPERATE THE TOASTER WITHOUT, THE REFLECTOR/CRUMB TRAY IN POSITION UNDER THE CONVEYOR CHAIN.

3.Check that the Bread Drawer is positioned flat on toaster base and pushed to ths rear until it stops. (Note: Bread Drawer is installed or removed by lifting the front handle at an angle so that the rear edge of drawer slides under the two front internal studs on right and left sides of toaster walls.)

4.Check that the Bread Slide is situated internally so that the '''tabs'' on each side are' resting behind the two rear internal studs on right and left sides of toaster walls. The front edge of the Bread Slide rests on top of the two front internal studs on right and left sides of the toaster walls. The Bread Slide should be covering the rear portion of the bread drawer.

5.Attach the optional Superfeeder on the, rod and pins located in front of the conveyor belt as shown in the illustration.

11