Paradyne 1900 manual Task 007 Installing the Data Network Connection with an MIU

2. BitStorm 1900 Installation and Testing

Task 007: Installing the Data Network Connection with an MIU

Use this procedure to connect the BitStorm 1900 to the Ethernet data network using an MIU.

Requirements

This procedure requires the following:

•Ethernet data network installed

•Serial cable and DB9S to RJ-11 serial adapter (included)

•PC with serial port to configure system

•Two Category 5 crossover or straight cables terminated with RJ-45 connectors according to Table 2-1.

Table 2-1: Data Cable Selection for MIU Shelf Processor

MIU	Cable Requirements	Application
RS-232	RJ-11 cable (a DB9S to	To a PC (for configura-
	RJ-11 serial adapter is	tion only)
	included)
Ethernet Pass Thru	50-pin connector decapus	To Ethernet switch
	cable (DB50F) part #
	04-00017-01, with 10
	RJ-45 cables (included)
10 Base-T X (top port)	RJ-45 straight cable, 6’	To a port on an interme-
	(included)	diate switch or hub
(Management ports
		NOTE: Switch or hub must
must be connected)
		have connection to
		EtherLoop network
		router.
10 Base-T (bottom port)	Not used in this release	Not used in this release

Step Procedure

1.) Connect one end of the RJ-45 (crossed) cable to the switch/router, then route the other end to the 10 Base T-X port of MIU.

2-54 BitStorm 1900 Installation and Maintenance Guide 1900-A2-GN20-00