Paradyne 1900 manual Task 017 EtherLoop End-to-End Testing

2. BitStorm 1900 Installation and Testing

Task 017: EtherLoop End-to-End Testing

This procedure checks the EtherLoop system installation, including simultaneous voice and data EtherLoop tests from the modem to the voice and data networks.

Requirements

The EtherLoop end-to-end system testing requires the following:

•Modem installed and powered

•Data network equipment installed and configured, including connection from EtherLoop to Internet, Intranet or LAN

•User room telephone or telephone test set with RJ-11 connection to the StormPort modem

•Ethernet 10Base-T cable with RJ-45 terminations

•Laptop personal computer equipped with the following:

•Ethernet PC card configured for TCP/IP

•Ethernet PC card RJ-45 adapter cable

•Internet browser application, either Internet Explorer 4.0 (or higher) or Netscape Navigator 3.0/4.0 (or higher)

Step Procedure

1.) Identify the modem pair being tested.

2.) Verify dial tone on the room phone.

3.) If the laptop is running, shut it down.

4.) Connect the Ethernet PC card RJ-45 adapter cable to the Ethernet PC card.

5.) Connect one RJ-45 plug of the Ethernet cable to the PC card RJ- 45 adapter, and the other end to the "To PC" RJ-45 port on the StormPort modem.

6.) Start the laptop, and launch the browser application.

1900-A2-GN20-00 BitStorm 1900 Installation and Maintenance Guide 2-101