Paradyne 1900 manual MIU Card with Cable Connections

2. BitStorm 1900 Installation and Testing

Step Procedure (continued)

2.) Connect the 50-pin connector to the Ethernet Pass-Thru port, then connect the cables at the other end to the corresponding switch(es). Refer to Figure 2-11(shown below).

3.) Connect the RJ-11 cable with the adapter (DB9S to RJ-11) to the local craft terminal (PC/laptop). Then connect the other end to the RS-232 port on the MIU. Refer to Figure 2-11(shown below).

4.) Verify that the green LED at the EtherLoop hub/router port illuminates, indicating connectivity is established from the BitStorm 1900 Access Multiplexer shelf to the switch/router.

Figure 2-11: MIU Card with Cable Connections

RJ11 Serial Port (This port connects to the craft terminal)

Ethernet Pass-Thru

10Base T-X

(This port connects to the switch/router)

10Base T

(This port is not currently used)

02-17183

2-56 BitStorm 1900 Installation and Maintenance Guide 1900-A2-GN20-00