C.INSTALLATION
1.Place the toaster on a flat surface and in such a way that the unit's vents are not blocked. Air must circulate under and through vent provided on the base, left side and at the rear of the unit. A minimum clearance of one inch (1", 2.6 cm) is required on the base and two inches (2", 5.2 cm) on the left side and rear of unit. Overhead clearance should allow heat to be dispelled adequately.
2.Locate the unit near a wall receptacle of the proper configuration. DO NOT USE AN EXTENSION CORD. Plug the power supply cord into an outlet of the voltage specified on the unit's rating label plate. Outlets must be grounded properly.
CONVERTIBLE AT SERIES TOASTER
To convert an AT Toaster from front return to rear exit, follow steps indicated in Figures 1 to 3.
Figure 1:
1.Turn off unit and let cool.
2.Remove Breadslide through front of unit.
3.Extra line if needed.
Figure 2:
1.Flip Breadslide over.
2.Insert Breadslide through back opening.
3.Place on conveyor belt.
Figure 3:
1.Turn on unit.
2.Conveyor belt will move Breadslide to rest on locator pins.
3.Ready to operate in rear exit mode.
FIGURE 1
FIGURE 2
FIGURE 2
12