Wegener Communications 562 manual Installation, Unpacking and Inspection, Location and Mounting

Unity 552 User’s Manual

CHAPTER 2 INSTALLATION

This chapter provides instructions on unpacking, mounting, and connecting your iPump 562 as well as connector information including detailed pinouts.

2.1 Unpacking and Inspection

Carefully unpack the unit and its ac power cord and inspect for obvious signs of physical damage that might have occurred during shipment. Any damage claims must be reported to the carrier immediately. Be sure to check the package contents carefully for important documents and materials.

Note: Please save the packing materials and original shipping containers in case you must later return the unit for repair. Packing these units in other containers in such a way that they are damaged will void your warranty.

2.2 Location and Mounting

	The iPump 562 may be mounted in a standard 19-inch equipment rack or set up for desktop
	operation. In either location, maintain a clean, dry environment for the iPump 562.
Precautions	FCC-Mandated Suppression of Radio Frequency Emissions
WARNING	This is a Class A product. In a domestic environment this product may cause radio
	interference for which the user may need to take mitigating action.
	If the Ethernet port has a cable connected to it, that cable must be properly shielded and
	grounded to minimize RF emissions that could interfere with nearby equipment.
DANGER	To avoid damage to the iPump 562 unit and other equipment, or personal injury, the
	following items should be strictly observed.
	Elevated Ambient Operating Temperatures in Rack-Mounted Units
	When equipment is installed in a closed or multi-unit rack assembly, the ambient operating
	temperature of the rack environment may be greater than the room's ambient temperature.
	Therefore, consideration should be given to the ambient air temperature within the rack (not
	just inside the room) when deciding if the maximum recommended ambient operating
	temperature (TMRA) is met or exceeded.
	Reduced Air Flow
	Equipment should be installed such that the airflow required for safe operation of the
	equipment is not compromised. The iPump 562 may be arranged in a rack without empty
	spaces between units, if heat buildup is prevented by ensuring that the side vents remain
	unblocked, and that there is adequate clearance around the vent holes.
	Mechanical Loading
	Rack-mounted equipment should be installed in such a way that a hazardous condition is
	not produced by uneven loading. The iPump 562 unit is not very heavy, but total rack
www.wegener.com	800092-01 Rev. A	11