Wegener Communications 562 manual Date and Time Information Settings, Set Unit Label, Yes / No

Operation

Figure 3.20: iPump 562 OSD Date/Time Setup

Use the Date/Time Setup screen to set and display the date and time information.

Table 3.13: Date and Time Information Settings

Option	Possible values
Current Date	Yyyy/mm/dd
Current Time	Hh:mm:ss
Time zone	All available…
DST	Yes / No

Set Unit Label

Use following steps to display Unit Label Setup screen on the OSD menu:

1.Navigate to the Unit Setup screen, see Unit Setup screen on page 23.

2.Press the down arrow button to select Unit Label.

3.Press Enter.

4.When the six-character label is selected, use the up/down and left/right buttons to set to a desired label. Press Enter to save the change. Use the left arrow button to go to the previous menu level.

Switch Application (to different software version)

Use following steps to display Application Switch screen on the OSD menu:

1.Navigate to the Unit Setup screen, see Unit Setup screen on page 23.

2.Press the down arrow button to select Switch Application.

3.View the details as shown in Figure 3.21.

4.Use the Application Switch to run a backup version of the software on the unit. Upon selecting the Backup Software by pressing Enter, the system restarts with the different software which is labeled as current. The previously run software is labeled

30 800092-01 Rev. A www.wegener.com