Wegener Communications 562 manual Technical Specifica- tions, RF Characteristics

		Unity 552 User’s Manual
	External Input/Output Interfaces
	Contact Closure GPIO DB-9 Female
Connector Pin	Input/Output	Description
1		Alarm Common
2		Alarm Normally Open
3		Contact Closure Common
4		No Connection
5	Input	Contact Closure GPIO Input
		(Factory use only)
6		Alarm Normally Closed
7		Contact Closure Normally Closed
8		Contact Closure Normally Open
9	NA	Ground
	Power DC IN 12 V 5 A
Connector	Input/Output	Description
Standard IEC	Input	115 or 230 V AC

Technical Specifica- tions

The following tables detail the technical specifications for the iPump 562.

RF Characteristics

Table 1.3: iPump 562 RF Characteristics

RF Characteristics

RF Input	Connector Type F
Input Frequency Range	950 - 2150 MHz
Input Level Range	-25 to -65dBm
Maximum Aggregate Input Power	-8 dBm at max input signal
Input Impedance	75 ohms
Input VSWR	< 2.5:1
Input Noise Figure	8 dB MAX at minimum input level
L.O. Leakage at Input	< -55 dBm
Demodulator	FEC Rate 1/2, 2/3, 3/4, 5/6, or 7/8 (1.0 to 45 MBaud) ½, 2/3,
DVB-S QPSK	¾, 4/5, 5/6, 7/8, 9/10 (2 to 30 MBaud) 2/3, ¾, 5/6, 8/9, 9/10
	(3 to 30 MBaud) Convert Symbol Rate Fs to Transport Rate
DVB-S2 QPSK
	Ft by: (2R*Fs)*(188/204)=Ft, where 'R' is inner FEC code
DVB-S2, 8PSK
	ratio, either R=1/2, 2/3, 3/4, 5/6, or 7/8.
Max Symbol-rate	S2 = 30 Msps; S1 = 45 Mbps

www.wegener.com 800092-01 Rev. A 5