Operation
Configure LNB options
Figure 3.5: iPump 562 OSD Current Channel Screen
Use the Current Channel screen to set or display the channel information.
Table 3.3: Channel Information Options
Option | Possible values | Comments |
|
|
|
Preset | Perm, Command, Last | Only Perm option allows other options to be set. |
| Success or Current | The channel set using the Compel Command. |
|
|
|
Modulation | QPSK/S2QPSK/S28PSK | - |
|
|
|
FEC Ratio | 1/2, 2/3, ¾, 5/6, 7/8 | - |
|
|
|
Frequency |
|
|
|
|
|
Data Rate |
|
|
|
|
|
Symbol Rate |
| Automatically calculated and displayed only |
|
|
|
Program |
| Set to the desired program # in the carrier |
|
|
|
Tag Site |
| The tag #15 is a special value |
|
|
|
LNB Setup screen
Use following steps to display LNB Setup screen on the OSD menu:
1.Press any
2.Press the down arrow button to select Carrier Settings.
3.Press Enter.
4.Press the down arrow button to select LNB Setup.
5.Press Enter. Figure 3.6 details the LNB Setup screen.
6.To navigate the screen, use down arrow and Enter to select an option. When the corresponding value of that option on the left is selected, use up or down buttons to set to the desired setting. Press Enter when done. Move to the next option using up or down button or left arrow to exit to the previous menu level.
18 | www.wegener.com |
