Extron electronic SCP 226, SCP 104 manual Front Panel Features

Front Panel Features

The controls on the SCP 104/226 replicate the programmed MLC 104/226 buttons and controls, and most of the System 5 IP front panel controls. All button functions for the MLCs and the System 5 IP are configured via RS-232 or Ethernet.

Any action taken at the SCP front panel, such as turning the knob to increase or decrease volume, pressing a button to turn the projector on or off, or pressing a button to select an input, is reflected on the attached MLC or System 5 IP front panel and vice versa.

NOTE: On the MLCs, the buttons can be programmed to

light bright green, red, or amber when selected; and

the SCP buttons reflect the programming on the

MLC. Buttons that are not selected light dim amber.

On the System 5 IP, only the buttons indicated by

B in the following front panel illustrations and

button #6 in group C can be programmed to light in the three colors.

See the Global Configurator help file for instructions on programming the buttons.

When a button is pressed or the knob is turned on the SCP front panel, the action is communicated through the RS-232 port. Use a tool such as Extron DataViewer on a computer that is connected to the RS-232 port on the SCP to view this information.

You can also issue SIS commands to the SCP to light LEDs and buttons (see the “Remote Communication” section, beginning on page 31, for information on SIS commands\⤀.

21SCP 104 and SCP 226 • Installation and Operation