FVolume knob and indicator LEDs — Turn this knob to adjust the volume on the input that is currently selected. The five LEDs light incrementally, bottom to top, to indicate the current volume level, as shown in figure 26. The top LED
is red; the others are green.
VOLUME | VOLUME | VOLUME |
LED Off |
|
|
LED Blinking |
|
|
LED On |
|
|
0% (Min) or Mute | ||
VOLUME | VOLUME | VOLUME |
Figure 26. Volume Indicator LEDs
GFaceplate attachment screws — These four screws (six, on the SCP 226 AAP\⤀ secure the faceplate to the SCP.
ATTENTION: Do not remove these screws after the SCP has been installed in a wall or lectern.
Resetting
To reset the SCP to the factory default version of the firmware, press and hold the buttons numbered 1 and 3 on the front panel while applying power to the unit.
PROJECTOR
ON OFF
VOLUME
1
2
3
4
SCP 104
To reset, press and hold these buttons simultaneously while applying power.
Figure 27. Resetting the SCP 104 to Factory Defaults
26SCP 104 and SCP 226 • Installation and Operation