Connecting to the MLC 104/226, the System 5 IP, and Control Modules
The diagrams on the following pages illustrate how to connect the SCP to the MLC 104, MLC 226, control modules such as IRCMs or RCMs, and the System 5 IP system switcher.
NOTES: • When an SCP 104 is connected to an
MLC 104 IP Plus, the SCP must have firmware version 1.01 or higher.
• When an SCP 104/226 is connected to a System 5 IP switcher, the SCP must have firmware version 1.01 or higher loaded, and the switcher must have firmware version 2.01 or higher.
• The diagrams in this section are guides; the SCPs, control modules, and IR Link can be
SCP 104 to MLC 104 IP Plus |
|
|
| |
COMM LINK | MLC 104 IP Plus |
|
|
|
A B C D E | Rear Panel |
|
|
|
OUT+V GROUND CM INIR SCP | DISPLAY |
|
| |
| ON | OFF | VCR | 1 |
E | SCP Communication | VOLUME | DVD | 2 |
|
| |||
|
|
| ||
|
|
| PC | 3 |
B Ground ( ) & Drain Wire |
| CONFIG |
| |
A | +12 VDC |
|
| |
|
| 4 |
200' (61 m) max. | SCP 104 | |
to Last Device | ||
SCP 104 | ||
|
Extron CTLP Cable Color Code:
ESCP Communication = White D Modulated IR (for IR Link)
C Control Module Communication
B | Ground ( |
| ) & Drain Wire |
| = Black & Drain Wire | |
|
| |||||
| ||||||
|
| |||||
A | +12 VDC |
|
| = Red | ||
|
|
|
|
|
|
|
NOTE: DIP switch 4 must be in the On (up) position.
Figure 10. Connecting the SCP 104 to the MLC 104 IP Plus
13SCP 104 and SCP 226 • Installation and Operation