Bunn LCR-3 service manual User Notices, Moving Parts

USER NOTICES

Carefully read and follow all notices on the equipment and in this manual. They were written for your protec- tion. All notices are to be kept in good condition. Replace any unreadable or damaged labels.

00986.0002

To reduce the risk of electric shock, do not remove or open cover.

No user-serviceable parts inside. Authorized service personnel only. Disconnect power before servicing.

37881.0000

Optional Field Wiring

120/208 V, 37.6 A, 7820 W 1PH, 3-Wire + GND, 60HZ

120/240 V, 43.2 A, 10400 W

1PH, 3-Wire + GND, 60HZ

FOR USE ON INDIVIDUAL BRANCH CIRCUIT ONLY

120/208Y V, 32.8 A, 12000 W 3PH, 4-Wire + GND, 60HZ

28181.0004

	WARNING:	HOT LIQUIDS
37280.0000
REMINDER!		AIR FILTER
CLEAN AIR FILTER		CLEAN WEEKLY!
	WEEKLY	(LOCATED UNDER THE DISPENSER)
(LOCATED UNDER THE DISPENSER)		FILTRO DE AIRE
RECORDATORIO!
		LIMPIAR
LIMPIAR EL FILTRO DE		SEMANALMENTE!
AIRE SEMANALMENTE		(LOCALIZADO DEBAJO

As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of the Food and Drug Administration (FDA), this equipment must be installed with adequate backflow prevention to comply with federal, state and local codes. For models installed outside the U.S.A., you must comply with the applicable Plumb- ing /Sanitation Code for your area.

00656.0001

! CAUTION

Do not connect to a circuit operating at

00824.0002 more than 150 volts to ground.

27508.0000

Moving Parts.		Risk Of Electrical Shock.
Do not operate		Disconnect power before
unit with this		servicing unit.
panel removed.
	27442.0000

CHARGE

Type R134A, Amount 13 oz (368.6 gm) Design Pressures:

High 276 psi (19 bar) (1.9 MPa) Low 88 psi (6 bar) (0.61 MPa)

33461.0004

	TO MACHINE			BLK BLU	TO MACHINE	WHI
BLK	RED	BLU	WHI		RED

L1 L2 L3 N	TERMINAL		L1 L2 L3 N
	BLOCK
FROM POWER SOURCE			FROM POWER SOURCE
FOR 3-PHASE OPERATION		FOR SINGLE PHASE OPERATION

(LOCALIZADO DEBAJO

DEL DISPENSADOR)

DEL DISPENSADOR)

CONNECT INPUT WIRING TO	MOVE BLU WIRE INTO
L1,L2,L3 & N AS SHOWN.	TERMINAL BLOCK WITH BLACK

40054.0000

WIRE, CONNECT INPUT WIRING

37947.0002 TO L1, L2 & N AS SHOWN.

4 41129 060111