Bunn S/N DUAL068000 manual You Sure?, Are YOU SURE?, Enable ADS?, SET Temp

Page 31

PROGRAMMING THE BREWER (cont.)

COPY SETTINGS (NO NAME COFFEE SETTINGS ONLY) (cont.)

2.Press YES in this screen. The display should read LEFT ->->-> RIGHT.

3.If the initial programming was done on the left side of the brewer, press YES. The display will read ARE

YOU SURE?

4.If you are sure that the data should be transferred from left to right, press YES. The display will then read TRANSFER COMPLETE, and will automatically advance to the next function screen.

5.In the LEFT ->->-> RIGHT screen, if the program- ming was done on the right side and it is desired to transfer from right to left, press NO. The display will then read LEFT <-<-<- RIGHT .

6.If the initial programming was done on the right side of the brewer, press YES. The display will read

ARE YOU SURE?

7.If the data should be transferred from right to left, press YES. After the data is transferred, the display will read TRANSFER COMPLETE. This will appear for 3 seconds, then will exit to the next function screen. Brew settings for all flavors are not the same on both sides of the brewer, only the NO NAME setting has been transferred.

ENABLE ADS?

This function allows the operator to choose whether or not to display the advertising message that was en- tered into the brewer with an AD CARD. This message will be displayed when the brewer is not in use.

ENABLE ADS ?

NO DONE YES

P2721

Procedure to Enable/Disable Ads:

1.Press and hold upper right hidden switch until the display reads UNITS. Release switch. Continue to press and release switch until the display reads ENABLE ADS. The YES or NO will be flashing to indicate the current selection.

2.Press and release the NO to disable this function (no ads will be displayed on the screen), or;

3.Press and release the YES to enable this function (ads will be displayed on screen).

4.When finished, press and release DONE to save the new setting, exit the ENABLE ADS function and advance to the next function screen, SET TEMP. Another alternative is to press and release either of the ON/OFF switches located on the front switch panel to exit the ENABLE ADS function and return to the MAIN SCREEN.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ο

 

ο

 

ο

ο

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SET TEMP - Range: 185˚F (85˚C) to 205˚F (96˚C) This function allows the operator to set the brew

water temperature in the tank. It also sets the hot water faucet dispense temperature.

SET TEMP: XXX° (-) DONE (+)

P2721

Procedure to set brew temperature:

1.Press and hold upper right hidden switch until the display reads UNITS. Release switch. Continue to press and release switch until the display reads

SET TEMP.

Page 31

29877-3 062005

 

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Phone 217 529-6601 FAX 217 Dual SH DBCIntroduction BUNN-O-MATIC Commercial Product WarrantyTable of Contents 00656.0000 37881.0000 03408.0004 User Notices00658.0000 00831.0000230 volt ac models Electrical RequirementsPlumbing Requirements CE RequirementsPlumbing HOOK-UP Operating Controls Cleaning Initial SetupCoffee Brewing Glossary Programming Programming SwitchesImportant Programming Notes Read Carefully Programming the BrewerProgram Functions Level Recipes Using a Smart Funnel and a G9-2T DBC or MHG GrinderNot using a Smart Funnel and/or a G9-2T DBC or MHG Grinder Recipe Programing MethodsTo a LevelContinue To E To D ReturnsContinue to B Return to a Program Flow DiagramContinue to F Left Brew Valve Byps OZ/M Procedure for modifying units of measure Units Setting Units of MeasureSET NEW Recipe Procedure for Setting the RecipeThis function allows the operator to set Brew Sizes DONE? SET NEW RecipeSET NEW Recipes Procedure to program the coffee nameRight Otherwise, press Next to display no NameReview Recipes Review RECIPES/MODIFY RECIPES/SET UP no Name CoffeeProcedure for reviewing recipes TimesDone Coffee Name Modifyshownext Batches DONE? YES Brew OZ Setting or Adjusting Brew VOL- UmesBatches DONE? BypassModifying pulse brew SET Pulse BrewSET Pulse Brew NO-NAME Left ModifyshownextSET Pulse Brew Easy Pulse Setup TIMES? SET Pulse Brew Enter TimesDONE? SET Preinfusion Read % Bypass Procedure to modify drip timesSetup Complete Drip Time now displayed on non funnel lock units as wellOnly Procedure to copy settingsReads Copy Settings Assign RecipesSET Temp Enable ADS?YOU SURE? Are YOU SURE?SET Ready Procedure to set ready temperatureSET Temp Refill Range 20 toCalibrate Flow Spray OZ/M Procedure to adjust the flow rate settingProcedures to calibrate the sprayhead flow rate Bypass OZ/MCalibrate Flow Repeat steps 1 8 when calibrating the other sideProcedures to calibrate the bypass flow rate Repeat steps 1 9 when calibrating the other sideThis function allows the operator to track Not resettableProcedures to view/reset the brew counters Brew CountersServer Detect Funnel DetectServer not in Place Testing individual components outputs Service ToolsNothing Pressed Service Tools Procedure to test components outputsProcedure to test switches Left Brew ValveERS? Service ToolsProcedures to test servers Procedures to test coil frequencyProcedure to set factory defaults Factory DefaultsDisable the Server Detect func- tion TroubleshootingScreen Displayed Possible Cause Smart Funnel not fully inserted into the funnel rails TemperatureTroubleshooting Procedures Screen DisplayedTriac Failure Tank Heater failureControl Board/Thermistor failure Troubleshooting Brew cycle will not start No water Problem Possible Cause Troubleshooting ProcedureEquipment will not operate No power or incorrect voltage Data plate within +/- 10%Problem Possible Cause Limit Thermostat Power Possible CauseTank Heaters Triac ProblemProblem Possible Cause Troubleshooting Procedures For each brew cycle Consistently high or low beverage Brew Volume adjustmentWater temperature Level in serverTions Tank Heaters Remove and clean lime off tankWeak beverage Incorrect Recipe Age, preinfusion, or pulse brewDual SH with Smart Funnel DBC Schematic Wiring DiagramSchematic Wiring Diagram Dual SH DBC W/SMART Funnel Limit Thermostat MT1

S/N DUAL068000 specifications

The Bunn S/N DUAL068000 is a versatile and high-performance commercial coffee brewer designed for those who demand quality and efficiency in their coffee-making operations. This brewer is part of Bunn’s DUAL series, known for its innovative technology and robust construction, making it a favored choice among coffee shops, restaurants, and offices.

One of the standout features of the DUAL068000 is its dual brewing capability. This allows users to brew two different types of coffee simultaneously, ensuring a wide range of flavors and options for customers. The unit is equipped with two independent brewing chambers, each capable of producing a batch of coffee in a matter of minutes, which is ideal for high-volume settings.

The DUAL068000 utilizes Bunn’s state-of-the-art brewing technology, including its patented "Duo-Temp" brewing system. This technology ensures that water is heated to the optimal temperature, generally between 195°F and 205°F, for extracting the best flavors from coffee grounds. Furthermore, the unit features a precision digital control system with programmable settings, allowing users to fine-tune brew times and temperatures for consistent quality.

An innovative characteristic of the DUAL068000 is its energy efficiency. The brewer incorporates an energy-saving mode, reducing power consumption during off-peak hours without sacrificing performance when needed. This makes the brewer not only cost-effective but also environmentally friendly, aligning with the growing trend towards sustainability in the food and beverage industry.

In terms of construction, the Bunn S/N DUAL068000 boasts a durable stainless steel design, ensuring longevity and resistance to wear and tear. It is also designed with easy access to components for maintenance, making it convenient for operators to clean and service the machine as necessary.

Other notable features include an integrated hot water faucet for tea and instant beverages, the capability to brew into various container sizes, and a large reservoir that minimizes refill frequency.

In conclusion, the Bunn S/N DUAL068000 is an exemplary commercial coffee brewer that combines advanced technology, durable construction, and user-friendly features. Its dual brewing capability and energy-saving design make it a top choice for establishments looking to enhance their coffee offerings while maintaining efficiency and quality. With this brewer, businesses can cater to a diverse array of customer preferences, making it an invaluable asset in any beverage service environment.
Top Page Image Contents