CDA RC9321 manual Introduction, Assembling the backguard

Page 4

Introduction

Congratulations on your purchase of this CDA cooker which has been carefully designed and produced to give you many years of satisfactory use.

Before using this appliance it is essential that the following instructions are carefully read and fully understood.

We would emphasise that the installation section must be fully complied with for your safety to ensure that you obtain the maximum benefits from your appliance.

B

Assembling the backguard

Remove the two spacers “A” and the screw “B” from the rear of the cook- top.

Assemble the backguard as shown in figure 1 and

A

fix it by screwing the cen-

tral screw “B” and the

 

 

spacers “A”.

Fig. 1

Declaration of CE conformity

This cooker has been designed, constructed and marketed in compliance with:

-Safety requirements of EU Directive "Gas" 90/396/EEC;

-Safety requirements of EU Directive "Low Voltage" 2006/95/EC;

-Protection requirements of EU Directive "EMC" 2004/108/EC;

- Requirements of EU Directive 93/68/EEC.

 

GB

4

Image 4
Contents RC9321 Twin Cavity Gas Cooker CDA Contents Introduction Assembling the backguardFeatures and technical data Gas burnersControl panel Minute counterHob burners How to use the hob burnersLighting of the hob burners Choice of burner Burners Pan diameterCorrect use of triple-ring burner How to use the gas oven left oven General featuresOven burner Oven thermostatLighting the oven gas burner Oven cookingHow to use the gas grill left oven Lighting the grill gas burnerUse of the grill Oven lightHow to use the gas oven right oven Lighting the oven gas burner How to use the gas grill right oven Important Warning Rotisserie right oven Use of the rotisserieOven cooking temperatures Do’s and do not’s Do’s and do not’sImportant notes For your safetyOven door guard Care and maintenance Cleaning the hobFlexible tube Gas tapsEnamelled parts Changing the oven lightBurners Triple ring burnerRemoval of the inner glass door panel Storage compartmentInside of oven Assembling and remov- ing the side racksDoor assembly Removing the oven doorFor the Installer LocationAir Vent Fitting the adjustable feet Moving the cooker Levelling the cookerStability bracket Provision for ventilation Gas installation Important NoteInstallation to Natural Gas Gas connectionLeft gas Right gas Inlet pipe 200 mm 700 mm Adjusting of the minimum of the top burners Injectors replacement of top burnersConversion to Natural Gas or to LPG Table for the choice of the injectors Oven burner and grill burner replacement of injectors Left OvenRegulation of air supply to oven and grill burners Right Oven Regulation of air supply to oven and grill burners Left and Right Ovens Regulating of the oven minimumLubrication of the gas taps Electrical installation For your safety please read the following informationElectrical feeder cable connection Feeder cable section type H05RRFAppliance servicing Guarantee Limit of CoverPage Page RC 9321 .. cookers