Conversion to Natural Gas or to LPG
Injectors replacement of top burners
Every cooker is provided with a set of injec- tors for the various types of gas.
Injectors not supplied can be obtained from the
Select the injectors to be replaced accord- ing to the table at page 39.
The nozzle diameters, expressed in hun- dredths of a millimetre, are marked on the body of each injector.
To replace the injectors proceed as follows:
–Remove the grids and extract the burner bodies.
–Using a wrench, substitute the nozzle injectors “J” (Figs. 44a - 44b) with those most suitable for the kind of gas for which it is to be used (see “Table for the choice of the injectors”).
The burners are constructed in such a way so as not to require the regula- tion of the primary air.
Adjusting of the minimum of the top burners
Considering that in the minimum position the flame must have a length of about 4
mmand must remain lit even with a quick turn from the maximum position to that of minimum.
The flame adjustment is done in the follow- ing way:
–Turn on the burner
–Turn the tap to the MINIMUM position
–Take off the knob
–With a thin screwdriver turn the screw F until adjustment is correct (fig. 45).
Normally for LPG, tighten up the regu- lation screw.
38
J
Fig. 44a
J
Fig. 44b
F |
Fig. 45 |