CHECK OUT PROCEDURE AND ADJUSTMENT
Figure 27 - Manifold Pressure Measurement Detail
Following steps and diagram indicate location of the connection points required to measure manifold pressure.
Manifold pressure may be measured using a
Remove plug. Install appropriate barbed fitting and connect pressure side line from
Refer to “Differential Air Pressure Switch Check” on page 49 when reading manifold pressure.
When measurement is complete, disconnect
Figure 28 - Gas Valve
PRESSURE REGULATOR
ADJUSTMENT (UNDER CAP SCREW)
VR8205
INLET
PRESSURE
TAP
INLET
ON
WIRING TERMINALS (2)
OUTLET
PRESSURE
TAP
OUTLET
NOTICE
Regulator cover screw must be installed at all times un- less adjusting manifold pressure. Firing rate and manifold pressure must only be measured with cover screw firmly installed.
OFF
GAS CONTROL KNOB
44