Haier HDW12-TFE3SS End of programme, Switching the dishwasher OFF, Interrupting the programme

Page 15

End of programme

14

EN

End of programme

Six beeps will indicate that the wash cycle has finished and the state indicators "A" light.

Switching the dishwasher OFF

Several minutes after the programme has ended:

Set On-Off button to Off

Open the door .

Turn the water tap off.

Remove dishes, etc. when they have cooled down.

Notice:

When the appliance is already underway press the button "B" for 3 seconds, all of the settings will be cancelled.

Interrupting the programme

Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating.

When you open the door, the dishwasher will beep ten times every thirty seconds.

If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion.

Delayed start programming

You can delay the start of a programme in increments of 1 hour up to 24 hours. Close the door after loading the appliance.

Switch dishwasher ON.

Immediately press the Delayed Start button “ F ”, the delayed start indicator “ E ” blinks, the remain-

ing time indicator “ G ” changes to “ ”.

Press the Delayed Start button for 2 seconds until the numerical display show the required delay.

To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator “ E” goes out.

Rotate programme knob “ J ” to select the desired programme.

A C E H

B D F G IJ

Image 15

Contents 0120504778D Dishwasher HDW12-TFE3SS HDW12-TFE3WH Instructions for UseIndex Safety information During installationAt time of delivery During normal useDangerous voltage If a fault occursWhen disposing of old appliances If your family includes childrenCold water connection InstallationPositioning the appliance Levelling the applianceElectrical Connection Drain hose connectionGetting to know your dishwasher Close-up view control panelDishwasher interior When the low rinse aid indicator Hon the control panel and the me How to fill rinse aidRinse aid Loading the rinse aidHow to fill the detergent dispenser DetergentLoading the detergent Damage to glassware and other dishes Not suitable for the dishwasherWhat you should not put into the dishwasher Our recommendationPots, serving bowls, etc. must always be placed face down. see fig.C How to use the lower rackArranging crockery, glasses, etc. in the dishwasher EN Pull out the rack to load the dishwasherHow to use the upper rack ShelfKnife rack QUICK RINSE Programme overviewTypes of load HEAVY NORMALEarn savings Switching the dishwasher ONWashing dishes Programme selectionDelayed start programming Switching the dishwasher OFFEnd of programme Interrupting the programmeTo select HALF LOAD Cancelling or modifying a cycleReset drain function HALF LOAD ButtonAfter Every Wash How to keep your dishwasher in shapeNo solvents or Abrasive Cleaning Products When You Go on HolidayFilters Care and maintenanceOverall condition of appliance Rinse-aidSpray arms Trouble ShootingResolving minor problems yourself Problems when the appliance is switched onHave you checked whether Error display on the time-remaining indicatorLower spray arm rotates with difficulty Lid in detergent compartment cannot be closedRemnants of detergent stuck inside dispenser Unusual amount of foam is creased during washingwith the dishes,cutlery, etc Water remains inside appliance after programme has endedGlasses have a dull appearance Plastic items are discolouredWhite stains are left on crockery, glasses have a milky appearance Dishes,cultlery,etc.have not been driedTechnical data Important informationNotes on waste disposal General information