This sectionprovides troubleshooting information in the form of an
If a problem occurs during the first operation of a new fryer, recheckthe installation per Section2 of this manual.
Before troubleshooting, always recheckthe operating procedure per Section3 of this manual.
e T | LES | In the event of a control systemfailure, the digital display will |
|
| show an “Error Message.”Thesemessagesare coded: E5, E4, E6, |
|
| ElO, E15, E41, E50, E51, and E53. |
|
| en turn switc |
|
| display showsE4, the control board is getting too hot. Checkthe |
|
| louvers on eachside of the unit for obstuctions. If E4 persists, |
|
| Turn switch to OFF position, then turn switch back to ON. If |
|
| display showsE6, thermal sensormust be replaced.Refer to |
|
| |
|
| button. If high limit doesnot reset,high limit must be replaced |
|
| per |
El5 | Drain Switch | Close drain, using the drain valve handle. If display still shows |
| Failure | E 15 check drain valve section6- 13. |
E41, E50, | Programming | Turn switch to OFF, then back to ON. If display showsany of |
E51, E53 | Failure | the error codes,the control panel needsreplaced. |