Grindmaster instruction manual Model LCD-2R and LCD-2A

Page 4

Warning Labels

The following warning labels were on your dispenser when it was shipped from the factory. They should remain on your dispenser in good, readable condition at all times. If one of your labels is missing or damaged, order a replace- ment label immediately.

Part #62981, Located on lower splash panel on front of dispenser

Part #61321, Located behind the drip pan on the front of the dispenser

Part #61319, Located on the outside on the back of the dispenser and on the outside on the electrical access panels

Part #61325, Located on the drain hose inside the dispenser

Page 4	Model LCD-2R and LCD-2A

Image 4

Contents Grindmaster Corporation Introduction User Replaceable Parts Model LCD-2R and LCD-2A Water Inlet Connection InstallationWater hook-up Backside of access panel Figure BHow to Dispense a Cup of Coffee On models with manual dispense pull handle switchesBag-in-Box Hook-up To flush dispense spoutsUser Programming Instructions Engineer Program Settings Engineer ModeMachine Fault Codes Reset System Water overheatLeak Inlet valve leakProgramming Guide for Calibration of Mix Ratio Important Note Regarding Portion Override ButtonProgramming Guide for Calibration of Mix Ratio Worksheet Dispensed WaterDispensed Concentrate Mix Ratio CalculationWeekly Cleaning Instructions Figure EDraining the Tank Service and CleaningPurging Machine of all Water for Shipment in Cold Areas Troubleshooting Guide Control Board Diagnostic LEDsProblem/Cause Remedy Machine does not Power UPWater Continues to Drip from Dispense Spout 21752/3&% Grindmaster Corporation Form # AM-328-04 63543