Grindmaster LCD-2A, LCD-2R instruction manual Introduction

Page 2

Introduction

The Grindmaster-Cecilware Liquid Coffee Dispensers (LCD-2A) and the Liquid Coffee Chilled Dispenser (LCD-2R) deliver two types of coffee made from liquid concentrate plus hot water.

The dispenser can be set up for continuous draw (by the cup) for self-serve applications, or portion-control to fill carafes and decanters for wait staff. The standard machine allows for (2) portion sizes per dispense head with the use of a hidden override switch located on the bottom left side of the door. If the override switch is pushed, the user has (10) seconds to activate a switch to achieve the override portion setting programmed for that dispense head. Optionally, the machine can be fitted with 2 portion touchpads.

Follow the concentrate manufacturer’s storage and shelf life recommendations. Product flavor profile is extended with chilled product storage cabinet featured in the LCD-2R.

The refrigerated model LCD-2R incorporates a Solid State Thermoelectric cooling system which requires little maintenance. Cleaning of the thermoelectric may be required on a periodic basis depending on the air quality of the loaction and should be performed only by a qualified technician.

This dispenser is designed to operate when the ambient temperatures are from 32°F (0°C) minimum to 86°F (30°C) maximum. Do not allow machine to operate or be stored below freezing temperatures or permanent damage will occur to machine unless water has been purged from all water lines.

Page 2

Model LCD-2R and LCD-2A

 

 

Image 2
Contents Grindmaster Corporation Introduction User Replaceable Parts Model LCD-2R and LCD-2A Water hook-up InstallationWater Inlet Connection Backside of access panel Figure BBag-in-Box Hook-up How to Dispense a Cup of CoffeeOn models with manual dispense pull handle switches To flush dispense spoutsUser Programming Instructions Engineer Program Settings Engineer ModeMachine Fault Codes Leak Reset SystemWater overheat Inlet valve leakProgramming Guide for Calibration of Mix Ratio Important Note Regarding Portion Override ButtonDispensed Concentrate Programming Guide for Calibration of Mix Ratio WorksheetDispensed Water Mix Ratio CalculationWeekly Cleaning Instructions Figure EPurging Machine of all Water for Shipment in Cold Areas Service and CleaningDraining the Tank Troubleshooting Guide Control Board Diagnostic LEDsProblem/Cause Remedy Machine does not Power UPWater Continues to Drip from Dispense Spout 21752/3&% Grindmaster Corporation Form # AM-328-04 63543