Backside of access panel, Figure B | Grindmaster LCD-2A, LCD-2R

Installation (cont.)

Electrical Hook-up: Ensure water connection is made to machine before proceeding and water source is

turned ON.

NOTE: Installation must be performed by a qualified electrician and must conform to all local and national codes.

NOTE: Machine is factory configured for field wiring and power cord is not provided. If the machine is intended to configured to 120 volt operation, a conversion kit 63578 is available for the addition of a proper 120 volt power cord and a serial tag conversion procedure to match the serial tag to the 120 volt wattage of the heater.

(Refer to Figure A).

The electrical ratings for your dispenser are

located on the serial plate on the outside cabinet.

For configuration of heater to optional wattages,

refer to configuration decal 50524-04 located on

the inside surface of the electrical access panel.

(see Figure B)

1. For cord connected models, plug the power

cord into an appropriate grounded and

dedicated electrical outlet. Go to step 8.

2. For hard-wired models not supplied with an

electrical cord, the dispenser should be

connected to a dedicated circuit with a fused

! "

disconnect switch or a circuit breaker near the

$%&' (

dispenser.

Strain relief knockouts are supplied on the

$$%$%&'()!*$&+,+& !-

!"#

back of the machine chassis for power entry.

./%01/+$.'23$/,+&1$.3%+$.

1'25/%1$.,+60%/+$.

•

Electrical connections and wiring

materials must conform to local codes and/or be in

Figure A

compliance with the National Electric Code.

•

Use only copper conductors

Remove the access panel located on

the lower right side of the dispenser.

Note: wiring diagram is on